Search results

  1. N

    1967 Chrysler 75hp: what am I missing

    My engine was running, now won't start. When key is turned it the starter works, but the engine itself won't start. Any ideas of what to look at next? Compression is good Spark is good Timed/adjusted according to Frank's tutorial. I even used the voltmeter test in the manual to test the...
  2. N

    1956 Evinrude Lark 30hp no spark after idle/high speed valves rattled loose

    Had the boat on the water the other day and both the low and high speed adjustment needles rattled loose. I tightened them on the water and got the motor running but it was real rough and died within a minute. Pulled the carb off yesterday and realized the packing washers on both adjustments...
  3. N

    Control Cable Bracket for 1967 Chrysler 75 hp model: 75773

    Just spent the last 2 weeks putting in a new floor on my 1967 Hidula C Craft and when I was connecting the control arm, the swivel bracket broke on me. So I have a few questions: Anyone selling the whole bracket assembly? Is the bracket assembly the same as a 1968 Chrysler 45hp(there is a...
  4. N

    Unclogging drain in 1956 Evinrude 30hp water LU

    I just pulled off the lower unit from an engine I bought; cleaned it up and replaced all the seals. I need to clear the drain that drains excess water/gas from the top of the LU(not where it is filled with oil). I cleaned out as much gunk as I could see from the top and all the dry dirt from...
  5. N

    Hole in LU of 1967 Chrysler 75hp?

    Is the hole below my "grease level" screw supposed to be there? Doesn't look like it, considering it leaks out oil/water mixture. Patching it would be easy enough, but I wanted to check to make sure it doesn't serve a purpose. It is marked with a blue arrow in this photo...
  6. N

    1967 Chrysler 75 hp model: 75773 fly wheel key

    You guys helped me fix my electrical system and I got my engine started. Then confirmed that a newer model LU would fit my engine, which it did. When I went to fire it up today with new LU installed, my previously corroded/beat up flywheel pin ended up shearing off on me and my flywheel spun...
  7. N

    1967-1970 Chrysler LU compatibility?

    Anyone know if a lower unit from a 1967 Chrysler 75hp model#: 75773 compatible with a 1970 Chrysler 85hp model#: 857ha? Or if the part numbers are stamped anywhere on the actual LU's? I am trying to find a parts manual I can buy that would probably tell me the answer, but have a feeling you...
  8. N

    Coil for 1967 Chrysler 75 hp model: 75773

    I recently picked up a 1967 Chrysler 75 hp 3 cylinder engine 75773 and am trying to get it running(I am new to working on outboards but learning quick). The engine is surprisingly clean, but I think it is because it hasn't been run much ever let alone recently. When turning the key, the...
Top