Search results

  1. E

    Johnson throttle cable removal

    I have a 1983 johnson 60 horsepower boat motor. I need to replace throttle cable. No problem removing it from the engine, but from the shift box I need help on how to get cable off. If you have pics that would also help. Thanks
  2. E

    Help with mounting trolling motor

    Also, The lip isn't raised much, but it does raise front holes off deck. I also have no access underneath so I'll have to use those rubber mounting minn kota makes I believe they are MkR-8.
  3. E

    Johnson 1983 60 hp tilt and trim

    I have a 1983 60 hp johnson. The tilt and trim runs ,but want lift. I know it needs fluid. Where do I put it in at and is pennzoil ok? It has set awhile and has leaked out, please help!
  4. E

    Shift rod housing cracked

    Trying to get out bushing, I cracked or took a chunk out of housing where bushing and o-ring sets. Any suggestions on what to do to fix or is it ruined. I did get bushing ang ring out.
  5. E

    3m -Johnson -evinrude- permatex aviation

    Which gasket sealant is best? Should it be used on drive shaft seal and on shift rod bushing and seal? Or grease or nothing?
  6. E

    Botched drive shaft seal

    I botched up the drive shaft seal trying to remove it. Any suggestions on how to get it out.
  7. E

    Seal removal on lower unit

    I bet this has been asked a million times. Having trouble getting out seals on lower unit of my 18HP evinrude 1960 model 15032. Any suggestions?
  8. E

    Skeg removal

    I have a 18 hp evinrude 1960 model 15032. I am replacing all lower unit seals, gaskets etc. having a hard time removing the skeg. I have a split skeg with all six bolts and one Phillips head removed on the side. Please help!
  9. E

    1960 evinrude

    I have a 1960 evinrude Fastwin 18 horsepower model number 15032. I need a new fuel filter. Where could I find one and what would be the part number. Thanks
Top