Search results

  1. K

    Verado DTS logic

    Hi, Does anyone happen to know how mercury DTS operates when you accidentally miss the neutral position and put directly from forward to reverse at high RPM? Does it wait until the RPM decreases or does it just try to engage and destroy the gear hub. Thanks
  2. K

    alpha one bellhousings

    Hi all, Question might sound a bit stupid but Iam a biy confused which bellhousing/outdrive I actually have. My outdrive s/n is 0D696374 which is alpha gen 2 but which is confusing me is that my U-joint bellow is attached with clamps on both ends and I have understood that alpha gen 2 should...
  3. K

    alpha gen 2 shift shaft bushing

    I ordered quicksilver shift shaft bushinkg kit 23-806036A-1. I only got one seal? is it right? I think I have seen two in pictures. And how about the installation of the seal(s): Which side goes up against bushing? the "open" or "closed" side? Thanks!
  4. K

    alpha gen 2 bellows replacement

    Hi, I found a little bit of water inside my u-joint bellows so I am thinking to replace it. Couple of questions before I start ordering parts: 1. What tools are needed in addition to hinge pin tools? 2. Which bellows is the hardest one to replace and does it make it any easier to use oem part...
  5. K

    alpha one gen 2 no reverse

    Hi guys, I have nercruiser 4.3 with alpha one gen 2. Today I lost reverse for some reason. I already tried to debug and what I did is that I removed the shift cable from the housing (next to carb) and I tried to push and pull the cable directly with my hands. It shifts well into forward but not...
  6. K

    4.3 LX gen+ performance with 22"

    Hi all, I have a -97 4.3 LX gen+ engine with 22 " prop on a sea ray 175BR. I took it on a test drive and the outcome was 46.6 mph at WOT and the RPM value was as low as 3600. According to my math skills this speed is not possible even in theory at this RPM value. I assume that outdrive gear...
Top