Search results

  1. P

    2002 Volvo Penta 5.7 gsi pefs has code 23 and wont clear?

    My 2002 Volvo penta with a 5.7 gsi TBI has code 23 which i believe is intake air temp sensor, but these engines dont have one. It had two codes. 13 and 23. I cleared them and 23 never goes away. Constant beeping while your driving. Runs rough and very little acceleration. Will go to 4000 rpm...
  2. P

    1999 Mercury 150 EFI Fresh rebuild runs but will not idle

    I purchased this boat knowing one piston was melted. I rebuilt the engine with OE Merc piston and ring sets on all holes. Good compression now. Sent the injectors out for complete rebuild and balance. Turns out #6 injector was bad and that was the piston that burnt. All back together and I have...
  3. P

    2003 Yamaha 225hp 2-Stroke Maintenance

    I bought a 2003 SF21 Skeeter Fishing boat with a 225hp Yamaha outboard. My question is besides the obvious water pump impeller, plugs, and oil is there anything I should be doing on this engine to maintain it before heading out this spring? It starts and runs nice right now and would like to...
  4. P

    89 Evinrude 225 hp 70psi Compression all Cylinders

    I am looking at buying an Evinrude 225 hp outboard so I did a compression test on it yesterday. It has been sitting for a number of years but still turned over ok. All 6 cylinders came up at 70 psi. My gauge is good because I checked my merc engine and they are all 120 psi. Could this low...
  5. P

    Need Pistons Force 120hp 1995 or Newer??

    I have a force 120 hp outboard and I need piston kits. The dealer tells me the pistons are different from 1995 and 96-up. This id what I have found out. The piston pins are held in with snap-rings so the Clymer manual says that 95 or newer. I have found a casting number under the electrical in...
  6. P

    Casting number on Force 120 Block Year???

    I have a 120 hp Force outboard and of course the ID tag has fell off. I have a casting number on the block #00-818154-05. Anyone know what year this block would be? I need pistons, etc. Thanks!!
Top