Search results

  1. B

    Removed flywheel

    I have a Mercury 650 4 cyl, Serial number 3000632. I removed the Flywheel by taking out all the bolts around the center rather than using a flywheel puller and didn't mark it's location. I also removed the Distributor so I have no reference point. Can I put it back on by finding TDC and...
  2. B

    Check for spark

    I have a 65 hp outboard and I don't have the controls for it but do have the engine connector with short wires on it.  Looking at the wiring diagram if I put 12 volt DC to the red wire going to the switch box will that give me spark when the engine spins?   Assuming the ignition system is good...
  3. B

    1968 Ted Williams Motor Parts

    I have a 1968 ted williams 9 hp motor built by McCulloch. I need the pulley the goes on top of the flywheel for the recoil start, Also dual poins and water pump. I've checked flebay and other online sources but no having much luck. My model number is 574-59740 and serial number 68600910.
  4. B

    Ebbtide Boat

    Looking for Photos of a 1973 Ebbtide Bushwacker. Just bought one in really rough shape. Looking to see what it is supposed to look like.
  5. B

    Test Black Stator

    Mercury 1150 2 cycle, serial number 3111152 with a black stator. Guy told me the motor would not start because the stator was bad. I removed it and tested with an Ohm meter and read 0.5 ohms. I believe this is a reading for a good stator, but would like to know if I am correct or not. Anyone...
  6. B

    Yamaha 9.9 T9.9E

    Most of the model number is missing so I hope what I have is enough. It is a 4 cycle and has the Solenoid on the top of the Carb. Does that work as the Choke, and if I put voltage to it out of the Carb should the rod move? If you put your hand over the horn it will start and run as long as you...
  7. B

    Year of Motor

    I have Mercury Model 200, 20 HP ad the serial # is 4104050 I've Googled the number and can't seem to find anything on it. Any help on where to find information would be greatly appreciated :joyous:
  8. B

    prop shaft

    I have a 1991 Mercuriser alpha one series one and hit a rock with the prop last time out. It broke the top off the drive shaft that goes through the water pump. I have the prop shaft bearing carrier out, the shift shaft out but the prop shaft won't come out. Does the water pump shaft have to...
  9. B

    Force 50, no power

    Compression is 120 in both cylinders. The plug in the bottom cylinder was fouled (wet) With the spark plug's out I removed the fuel line to the carb and ran a test hose from the fuel pump to a coffee can. Spun the engine with the starter and no fuel came out of the hose. But if I squeeze the...
Top