Search results

  1. woodduck110

    Suzuki DT140 not reacting to throttle

    Hello all, I have a 98 Suzuki DT140 that is acting up. It starts and idles just fine, and does well at low speed. When I push the throttle past this point the motor starts to hesitate/jerk and won't go any faster. This is a fuel injected engine. Does this sound like a fuel delivery issue? It sat...
  2. woodduck110

    96 Evinrude 48 spl starting issues

    Hello all, I have a 96 Evinrude 48 spl that has been running great up until just recently. Went to start it and it just floods out really quickly. Seems to not be getting any spark for some reason. The weather has been a little cooler past few days, but other than that nothing is different. I...
  3. woodduck110

    Suzuki DT140 compression readings

    Hello all, I am going to possibly buy a boat today and had a question about engine compression. the engine is a 97 Suzuki DT140. Any ideas what numbers would be good as far as compression readings from this engine? I'm still kinda new to outboards. Thanks for any info!
  4. woodduck110

    Possible water in hull?

    I own a Carolina Skiff J16 and I think its sitting too low in the rear. I'm the 3rd owner so not sure all that's been done to it. My waterline is like 7" high in the rear. I have a 48hp Evinrude, battery, and 6 gal fuel tank in the back also. Is it normal to sit this low in the water??
  5. woodduck110

    Need advice on transducer placement on a flat bottom skiff

    Hello all, recently got a fish finder for my Carolina Skiff J16. I'm having some issues trying to find the best location for the transducer because I have a high water line. I have a heavier 48hp on it now, but I suspect there could be some water in the hull in the rear also (I'm the 3rd owner)...
  6. woodduck110

    96 Mercruiser v6 fuel pump relay problem

    Hello all, Having a problem with my Fuel pump relay. It won't come on and prime the carbs when key is turned. It usually takes 4 or 5 times turning the key for it to activate. The engine is a 96 Mercruiser 4.3L V6 with electric fuel pump. I have checked the connections and it looks fine. Any...
  7. woodduck110

    Identifying engine year

    Hello all, someone gave me a parts motor and I'm trying to figure out what year it is. I know it is a Johnson 48 spl, 2 cyl. The number on the engine is 048eslccc. I have trying looking it up but haven't found anything. Thanks for any help.
  8. woodduck110

    Evinrude 48 spl overheating

    Hello all, need some advice to why my motor might be overheating. Its pumping water in and out just fine. does fine at low speeds but at about half throttle it runs for about a minute or 2 and then the overheating alarm comes on. took the hood off and the engine is very hot. All I have done to...
  9. woodduck110

    Tilt assist cylinder question

    Hello all, I have a 96 Evinrude 48 special which has manual tilt, apparently the tilt assist cylinder is supposed to help with lifting it. My engine will tilt up and down, but it takes a lot of effort. Do you think it has something to do with the cable on the cylinder? I have never inspected or...
  10. woodduck110

    What is this thing?

    Could anyone tell me what this bracket is used for? Just bought a boat and there's one on each side. It says goldeneye products on it. Thanks for any help!
  11. woodduck110

    Evinrude 48 Special question

    Hello, I'm new to outboards and have recently bought a boat with a 96 Evinrude 48 special outboard. I am wondering what is the function of the red switch on the side of the engine. When I start the motor I have to flip it forward first to get it to start, and then switch it back so it can run...
  12. woodduck110

    1996 Evinrude 48 spec not pumping water through

    Yesterday I was running my engine and all of a sudden it won't take in water or drain water from the tube in the rear. It will run but overheats quickly. Does anyone have any clue why it would stop drawing in water? thanks for any info
Top