Search results

  1. K

    1978 sea nymph resto

    Hi guys been long time since my last post. I acquired a 1978 sea nymph 17 foot deep V hull recently and decided to do a full restore due to transom holding a johnson 115hp was completely rotted out. i pulled motor and got what was left of the transom out and noticed the floor was also soft so i...
  2. K

    1975 chrysler 55 hp serial # 557hg throttle wont advance to WOT

    Here are pictures with throttle in idle with cam scribe line intersecting roller and throttle at wide open throttle and cam not completely opening the butterfly due to the stopper on the throttle shaft hitting the engine block, along with the picture of the throttle shaft part number which going...
  3. K

    1975 chrysler 55 hp serial # 557hg lower unit issue

    Hey guys, I recently got rid of my Ole rude and got my hands on thus chrysler for a pretty good price. So far I've rewired my boat and added a terminal block behind the dash to match the wire diagram to a T. I have replaced and added [New ignition coil] (Ignition switch) (Starter solenoid)...
  4. K

    Spring loaded barrel ( where to find )

    Hi I had seen an old post regarding the same question about these spring loaded barrels that the seloc manual names it. I went threw the old posts but did not see an answer, I have a 1975 chrysler force 55hp. Thus just re wired controls but am missing one spring loaded barrel to snap onto the...
  5. K

    1963 Evinrude Starflight III 75HP( how to tune Slow speed nozzles on face of carb)

    Hey fellas, Been a little bit since i have last posted. I have done a lot of work on my Rude and will post pictures when I get to them since my last computer took a crap on me and lost most of my files. anyways, I did end up getting my motor running and she did start up with no issues. What...
  6. K

    1961 Evinrude Starflite III mysterious black wire.

    Hey guys, i called it mysterious only because I do not know where or if it needs to be connected too, I followed it all the way into the I " assume the Junction box where the batter wires are connected to. From there I cannot tell where it goes as i think from what I can see it stops here. I...
  7. K

    1961 Evinrude Starflite III Timing ( Model # 50931 A )

    Hi I am starting a new thread from previous discussion in which I recieved a ton of help. I have a 1961 Evinrude Starflite III as most of you may already know who may chime in with additional information. I was able to take off the carb off and since I do not have the centering tool for the...
  8. K

    1961 Evinrude Starflite III start up issues

    Hi, I am brand new to this forum coming across it trying to find info on my 75hp evinrude. I can post pictures later. I got a 1961 MFG tri hull with the 61 startflite III motor equipped on the back end. I am the third owner of the boat as it came from a guy who purchased it off the original...
Top