Search results

  1. R

    1989 Mercury 100 4cyl - Ignition Spark Issue (S/N: OB346208)

    Relatively newbie here that just purchased 1989 Mercury 100 for a learning project. Mounted and rigged on project boat, but at WOT only getting 2,500rpm. New gas, new fuel lines, primer bulb, rebuilt carbs, performed link/sync. Starts with bump of the key, idles great, but no WOT. Checked spark...
  2. R

    1986 Mercury 50hp 3-cyl - Shift Shaft Disconnect

    I recently acquired a project boat with what I believe to be 1986 Mercury 50hp S/N: A 952458 (pic attached) I have not had success yet finding the factory service manual for this particular engine. I plan to drop the lower unit and replace the impeller, but didn't readily see how/where to...
  3. R

    1997 Mariner 115 2+2 wont go above 2,000 rpm

    I have a 1997 Mariner 115 2+2 (serial#: OG498217) on a 17' Alumacraft. It has been flawless for me since I acquired it in 2002. I removed the outboard last winter to complete transom replacement. I just got it in the water 8/18/18 and the motor started up great, idles fine, and runs flawlessly...
  4. R

    Removing trim unit 1979 90hp inline 6

    I'm going to tackle removing engine and trim system in order to restore some rotten transom and stringersee. Wondering get if anyone may have some advice for how to best remove the trim pump assembly and hoses fcontained within the rear bilge area.
  5. R

    Removing jet from carb

    I'm in the process of rebuilding the carbs on 1979 Mariner 90 hp inline 6. I can not remove the brass jets from any of the three carbs. Is there a trick to freeing them? I'm afraid to apply too much force as one has already started to deform the slot.
  6. R

    1979 Mariner 90hp Inline 6 - No Start, no fuel

    I picked up a project boat, motor and trailer for a self-education learning experience. It appears that the previous owner was in the midst of rigging this 1979 Mariner 90 hp in-line six engine to the boat and was far from done. I installed a fuel line from the gas tank to engine, purchased an...
  7. R

    1979 Mariner 90hp Wiring Harness to Engine

    Recently acquired a project boat with 90 hp Mariner inline 6 SN# 5310112. The plugs have been cut from both the control box wire harness and the engine harness. It think I have most of the wires figured out in order to hard wire the control box to engine, but have a single white wire form the...
Top