Search results

  1. S

    1976 Chrysler 105 running rough immediately after adjusting carbs on the water.

    My motor had ran really well for about an hour or two, until I decided to fine tune the carbs. Could just be coincidence, but it started acting up immediately after I made some adjustments. I had made this adjustment in a bucket, out of the water, but the instructions say to do it in gear, on...
  2. S

    Fuel connector compatibility issues.

    So I have a fuel tank and fuel line/bulb that has been used since about 2004 when we purchased a new Mercury. I've had a newer scepter fuel tank sitting in the garage for some time now, and decided to start using it. The quick connector will not fit properly. I tried drilling the receiver...
  3. S

    Clarification on Chrysler 105 w/ magnapower II ignition switch wiring.

    1976 Chrysler 105, magnapower II So this is my first time with an outboard. I am a bit confused by the wiring. It did not come with the controls, so I purchased separate. The new control box had no ignition, so I'm going to use a generic marine switch with a push to choke. I have the manual...
  4. S

    Questions on '76 Chrysler 105 first start after sitting for years.

    I recently acquired a 76 105 to be used on my sailboat. I was told the motor had been sitting for about 20 years. I have it up on a stand now. I took the cowling off and it looks to be really clean for its age. There are no signs that it's been worked on in the past (bolt/screw heads look...
  5. S

    2005 Mercury 25hp no water from indicator hole before or after impeller replacement

    Hello everyone. My father passed away a few months ago and I've taken over some of the duties over at my mom's house. I put his pontoon boat in the water and fired up the engine (2006 Mercury 25 hp 4-stroke) and noticed right away there was no water coming out of the indicator hole. It was...
Top