Search results

  1. B

    Mercury/Quicksilver trim hose threads

    I blew a line on my jack plate and need to order and/or get another made up...they are the same as the trim hoses. I am away from the boat so hopefully someone can confirm the thread size at either end that go into the jack plate cylinder and Mercruiser trim pump on the other end inside the...
  2. B

    1999 Mercury 115 2+2 running issues

    The engine has just been broken in running double oil and now filled tank with nothing but fresh gasoline...oil injection still hooked up. The carburetors have been gone through twice due to this issue as of now. The engine starts right up and idles good, especially after the link and sink...
  3. B

    Mercury 115 ELPTO stutter at operating temperature

    I am trying to chase down what I think is a fuel problem. Motor is a 1999 115 2 stroke...fresh rebuild...with about a dozen hours on it. The last tank I topped off...1/2 full...with regular gas to finish running double oil for break in. The engine starts and runs fine. Once up to operating...
  4. B

    Rectifier ignition help...'99 115hp L4

    I have a 1999 Mercury 115hp in line 4 cylinder 2 stroke. I just finished up a power head rebuild. Because of time lapse I pulled the battery and put a charge on it. Well, when I installed the battery back in the boat I attached the terminals crossed...positive cable to negative post and...
  5. B

    Mercury 115 L4

    I am currently putting my 2000 Mercury 115 L4 back together after replacing a burnt piston and honing the rest of the cylinders and new rings. I plan on using the Loctite 518 between the 2 halves of the block as the manual shows. However, I cannot find any documentation on the torque...
  6. B

    Mercury L4 115 manual

    I am finally in the stage of putting the motor back together and need the torque specs of the bolts that hold the 2 halves of the block together. It might also be good for me to see if I can locate a manual. The engine is a 1999 Mercury L4 115, serial number OG895702. Anybody help a guy out in...
  7. B

    Rebuild kits

    I will hopefully be cracking the case open on the '99 Mercury 115 elpto today...#4 hole is dead. I plan on rebuilding it and would like to know a good place for a rebuild kit given it is a fresh water motor and in good shape. I will have the machine shop mic the bores and see what I will need...
  8. B

    Mercury 100-125 elpto parts interchange

    I recently bought two outboards to get back on the water. The first one is a 1999 Mercury 115 and the second one is a 1994 Mariner Tracker 115. Both of these are fresh water motors and in good condition physically. The Mercury has a dead hole in cylinder number 4 and the Mariner is supposed...
  9. B

    Mercury 90-125 no power under load...not the common dirty carb fuel and/or stator issue...

    Mercury 90-125 no power under load...not the common dirty carb fuel and/or stator issue... I am trying to get my ole 182 Mako flats up and going. I purchased this hull some time back and have been restoring it. I removed all the wiring and fuel hoses...but did keep the battery cables given they...
Top