Search results

  1. H

    Suzuki Kill Switch Issue

    After previously running the motor during cleanup after a non-eventful run we put the boat away for a month or so during the cold Florida weather and when we launched, the motor would turn over but not start at the boat ramp. It acted just like the lanyard was not plugged in. The kill switch was...
  2. H

    Tach for a Sea Pro

    Does anyone know where I could find a tach as shown for a 2001 Sea Pro center console? Should I just buy a marine tach that fits the hole? Are there any merchants that stock used parts for different models of boats? Any help or suggestions would be appreciated.
  3. H

    Hooked up my battery with the wrong polarity

    Long story why I was so stupid, but I hooked up the wires to my battery on the wrong poles and when I switched it on I now have nothing working. Checked that I have power in and out of the cutoff switch but that is as far as I got. Does anyone know if boats have a fusible link or a single...
  4. H

    2001 Merc 115 EFI Won't Start with Idle Air Connected

    I have had a strange situation with my 2001 Merc 115 EFI. When I recently cleaned out the tiny filter for the high pressure fuel pump (for the fourth time) and restarted the motor I left the connector to the idle air control unplugged because that is the way I found it when I got the motor back...
  5. H

    Replacing the steering cable on an 18 ft center console

    I have what appears to be a broken cable on my 18 ft Sea Pro with a Merc 115. The cable goes into the floor in the console and comes out of the rear corner. I don't know whether it runs in a tube and I am not sure that I can access it while in the hull. How do I run the new cable if I can't get...
  6. H

    2001 Four Stroke 115 HP Idle Air Control Issue

    As many of you know the 2001 Mercury EFI 4 stroke motor is essentially a Yamaha with Mercury badging. I asked this question on the Mercury site and got no response, so hopefully the Yamaha experts are more willing to chime in. ​After completing a job on the VST, the motor wouldn't start. It...
  7. H

    2001 Mercury 4 stroke 115 Idle Air Issue

    I just completed a repair to the VST to clean the screen on the high pressure fuel pump and when the job was completed the motor would not start. The only difference between the way that I found the motor before doing the job, and after, was that I connected what was previously a loose connector...
  8. H

    Coating for the inside of the VST

    The moderator closed my previous thread on this subject because it got onto a contentious debate about Ethanol in Marine engines. Because of this I was unable to get any suggestions about what if anything could be used to coat the inside of a VST that had experienced the early signs of...
  9. H

    Ethanol Fuel Issues

    I read with interest the sticky post about Ethanol E10 gas being an acceptable marine fuel and that it may in fact be a better fuel than E0 for marine use. I would submit that the millions of dollars that are spent each year dealing with the results of this fuel stand in absolute rejection of...
  10. H

    2001 Mercury 4 stroke will not go to full throttle

    My 115 horse Merc outboard starts and runs great at low speeds and all the way up to about 3/4 throttle between 4000 and 4500 rpm. The gas was treated over the winter and the external fuel filter was just replaced. The fuel filter inside the cover was removed and checked without anything being...
Top