Search results

  1. T

    '95 Merc 502 dying on throttle up after idling for awhile

    Boat in my sig, '95 Merc 502 mag. Mechanical fuel pump and water separating spin-on fuel filter. Boat had a problem a few months ago when I first got it where if I idled for awhile, like going through a long no-wake zone, then left the no wake zone and tried to throttle up, it would just about...
  2. T

    Gelcoat delamination...DIY or pro territory?

    Found an area near the transom on my boat this past weekend where the gelcoat is cracked and starting to delaminate. There doesn't appear to be any damage to the underlying fiberglass, at least from what I can tell by looking at the inside of the hull. Is this DIY-able (never done gelcoat...
  3. T

    Havasu in the winter - what to check out?

    We just booked a 4 night trip at the Nautical Beachfront resort from Dec 28 - Jan 1. Dragging the Cobalt out there, planning to check out the lake and cruise up the river towards Laughlin as well. I've only been to Havasu once and that was 16 years ago, don't remember anything about it. Anyone...
  4. T

    Mirage vs Revolution 4 test results - thoughts?

    I have a demo 23" pitch Revolution 4 from bblades that I tested back-to-back with my original 23" pitch Mirage (plain Mirage, not Mirage Plus) yesterday. This is in a 1995 Cobalt 252 25' bowrider, 502 Mag, Bravo 1, 1.5 ratio. Both props are 23" pitch. Bblades is closed until Monday, planning to...
  5. T

    Strip, prime, and paint or just rough up and topcoat this drive?

    I'm going to repaint my Bravo drive this winter. Based on the condition in the pics below, do you guys think I should go all out and remove the drive, split the upper and lower, then strip/prime/paint it all, or just rough it up a bit and top coat it? I've been trying to read up on painting...
  6. T

    Merc 502 slow crank or normal?

    I feel like my 502 is cranking over a little on the slow side, wondering if I should look at replacing the starter. Batteries are new and have a full charge. Does this seem slow to anyone else or am I just being paranoid? First two videos are me jumping the slave solenoid so it will crank...
  7. T

    Fuel pressure test port, 1995 Merc 502 EFI

    I am looking at installing a fuel pressure gauge on my 1995 502 Mag EFI. Where is the correct location to install the sender? Does anyone know the thread size?
  8. T

    Anyone into skurfing?

    I used to wakeboard quite a bit behind a 2003 Tige 22V that we sold several years ago and got pretty decent, could do normal and switch wake-to-wake on both heel side and toe side, 180's, and even landed a handful of backrolls and 360's (although never consistently). Finally gave it up after...
Top