Search results

  1. Blown496

    water hose to engine question

    92 Mercruiser 305. The inlet hose connects to a pipe on the left lower side of the engine. Is that a one way valve? Do I need to pour antifreeze down that hose? Also, is pulling the hoses on both manifolds getting all the water out? I drained the block and pulled the tstat housing to replace the...
  2. Blown496

    Carpet install choices

    Does the new carpet in a 20’ bow rider go in as one full piece or sections? Are the sides of the hull separate pieces? My lake ready rotten boat had been re-decked with no fiberglass and hacked stringers then carpet glued on raw plywood. All the carpet came off in pieces. Now that this boat is...
  3. Blown496

    layers of csm new deck

    I have reached the point in my restoration of a crownline 196 that I have pb'd the plugs in the holes fI made for foam. I will say that tips about to use acetone for the stir stick and paper towels to clean my dollar store mixing cups was spot on. Messy but only needed one stir stick two small...
  4. Blown496

    How to finish deck edges

    how do I finish the edges of the new deck around the bilge opening? The deck was replaced but had no fiberglass or resin. Thus, the rebuild from bare hull up. Thanks
  5. Blown496

    Walk through window gap Fix

    In the process of restoring my Crownline 196 I thought about how much flex the boat had in the condition I bought it. It had floors replaced but the wood was just pushed under the edges of the cut out fiberglass from the original floor and carpeted over. So the entire floor was not tabbed to the...
  6. Blown496

    New engine stringers pre drill holes

    Does anyone have a way to mark the front mercruiser mounts on 305 crownline 196? I am ready to put the engine back in after my total rebuild and was thinking there must be an easier way than put it in without y pipe to mark holes then do it all over again with the y pipe. Every time I lug that...
  7. Blown496

    Nailers for soul and ski locker

    Not having muck luck searching this topic. Can I cover the nailers with cab and pb them to the stringers or screw them on after glassing?
  8. Blown496

    Pb mix for transom

    I got my cam on my new transom. First time mixing I figured about 7 sq ft to do taking quart of resin. The catalyst amount was cut in half per instructions since its 92 degrees. That was almost perfect and I had plenty of time to work it up. Can I do the same with pb?
  9. Blown496

    Drilling steering holes in new transom what angle?

    I guess I'm not searching right. I bought an angle guide for my drill. picture I took looks like about 45 degrees but does anyone know the correct angle. Sure don't want to mess it up.
  10. Blown496

    filling ladder holes

    I have removed the under platform ladder and am putting an above platform ladder on. When I put my new transom in I will glass over some of the holes. Can I drill them out and use epoxy like pc11 to fill all the holes?
  11. Blown496

    Questions Ready to bed stringers and transom

    My Crownline 196 is gutted and grinding done. I have all the wood cut and ready to go. I am getting my 475 pounds of material tomorrow. I am starting with pb bonding the transom first and practicing my pb method on the transom before I put it in the boat. I will csm the back side and am wanting...
  12. Blown496

    Router tops of stringers

    What size router bit do I need for 3/4 plywood? Do I round all the tops or just stringers? Thanks
Top