Search results

  1. M

    Outboard cowling insulation replacement

    The insulation/ sound deadner on my 25hp evinrude tracker outboard cowling is starting to flake and send little pieces of crap into my carb. Causing all sorts of problems. I want to replace it with new insulation/sound deadner. Any suggestions from ya'll. Ive seen some types used on video but...
  2. M

    Cmc tilt and trim, Help

    I purchased a used cmc tilt and trim and it was working ok, but I think the relays went bad. I wanted to replace the wire harness anyway due to it being very old. 01297 is the only numbers I could find on it. Can anyone help me find the correct wire harness. Thanks in advance
  3. M

    Mount a Johnson 20hp outboard permanent

    I have a question, may sound stupid but here goes. I have a 1966 Johnson 20hp outboard. I just bought a 16 ft alumacraft boat with steering. I'd like to mount the motor permanently. Not just over the transom top. Can it be done and what do I need to do it. There are no bolt holes in my...
  4. M

    Johnson outboard 20hp

    I've got a johnson 20hp outboard motor 1966. The bottom fin below the gear box is cracked. The number inside is 302492. Question is can I repair it with liquid metal if I cant find the part. I've been looking for a replacement part but just cant seem to find it. HELP lol.
  5. M

    1966 Johnson 20hp

    I was wondering if anyone knew if I could convert the pull start to electric start, the flywheel has teeth.
  6. M

    Nova chips

    Has anyone replaced there points and condenser with nova chips to make a electronic ignition on there outboard motor.
  7. M

    1961 evinrude 18hp impeller

    I've looked all over for something to tell me how to remove the lower so I can change the impeller. I cant find anything. Anyone have any ideas.. Thanks In Advance for help.
  8. M

    Unknown hp or year.

    I have a evinrude motor, not sure what hp it is. The numbers on the round silver thing on the motor itself says 1503409812, i tried to look up the numbers on line but only found the first set 15034 under a 1961 18hp. Can anyone help me out here. I want to get the motor running and would like to...
  9. M

    Johnson 6hp issues Aggghh

    I've got a 1969 johnson 6hp. I've done a carburetor kit job on it, it runs here at the house but when I get on the river, it either wont run at all or it only runs for a short time or it only runs about half and jumps... Help I'm at my wits end. All houses replaced and fuel pump replaced.
Top