Search results

  1. S

    Remove lower pin from Fastrak Trim system

    I have 1996 J150EXEDB johnson ocean runner equipped with the fastrak trim system. My motor is going out on the unit and I also suspect a leak in the system and want to rebuild it. I have pulled the wires from the grommet and removed the upper pin, however, the lower pin will not budge. It will...
  2. S

    Does My engine have a poppet valve??

    I have a 1996 Johnson Ocean Runner 150HP. Model j150exedb and am curious if this engine has a poppet valve? thanks
  3. S

    1996 150hp ocean runner running hot

    The engine will sound the warning horn after running fairly long periods of time at 4000 rpm or more. You can run under that all day long and it may never come on. Once it does sound the horn you can shut it down and start it right back up and continue to run without buzzer sounding again for a...
  4. S

    1996 150hp ocean runner running hot

    The engine will sound the warning horn after running fairly long periods of time at 4000 rpm or more. You can run under that all day long and it may never come on. Once it does sound the horn you can shut it down and start it right back up and continue to run without buzzer sounding again for a...
  5. S

    Cleaning water passages on 1996 150hp ocean runner

    I have a 1996 J150EXEDB that I am in the process of cleaning the water passages on. The question I have is regarding the black rtv sealant on the cylinder and heads. The sealant appears as if it is in the passages rather than around them. Can anyone please advise how I should re seal the...
  6. S

    Johnson ocean runner overheating

    I have a 1996 Ocean runner 150hp. I recently replaced waterpump and all seemed well. Recently went to coast and got in a little shallower water than meant to and ended up i think clogging the pump. Engine overheated and no water out of the tale tale "pisser". We got in deeper water and let...
  7. S

    1997 Johnson Ocean Runner 150HP Hesitates/Shutters

    I have a 1996 or 1997 J150EXEDB 150 Hp ocean runner. About 8 months ago i started experiencing what i thought my have been cavitation but this weekend it became apparent that it is not. Before when running cold the engine ran GREAT. After getting hot it would run to 4500 rpm fine anything more...
  8. S

    Motor Guide Trolling motor

    I have a SW82FBDigital trolling motor. It has been cutting out. It runs for a while then stops as if the breaker is being tripped. I have checked the breakers and bypassed them as well and it does the same thing. Before after running for a fairly long period of time..(across a cove/creek...
  9. S

    Center Console livewell broken/ 1997 Cajun 2100 fishmaster

    I have a cajun 2100 center console that the livewell has come separated. It seems the only way to repair this the right way is to turn the console over and re-glass it back to the console. Would this be very hard to do and is their an easier way. Seems all the controls/wires would have to be...
  10. S

    Moulding for 1997 Cajun FishMaster

    I am looking to re-carpet my boat. I was wondering where i could find the rubber moulding that goes around the railing of the boat. Also it seems as if you just unbend the aluminum studs under the rail to get it off. Is this easy to take off and put back on? What am i getting in to here? Thanks...
  11. S

    24 volt wiring

    Is it possible to run 4 batteries together on a 24 volt system. Paired in parallel then in a series for 24? I dont have a clue but mine dont seem to run for long periods of time. They are fairly new. Im running a 24 volt 82lb greatwhite digital motorguide. Thanks, swade
  12. S

    Johnson Ocean Runner 150 1996 missing at high speed

    I have a 1996 Oceanrunner that seems to be missing at high speeds. It only does it sometimes and seems to do it after it has been running for a while. I tested the spark and at .05 gap cylinders 1,3,5 fire very strong and rapid. Cylinders 2,4,6 fire intermittently and not at all it seems...
  13. S

    Motorguide 82lb foot control Greatwhite Digital

    This motor cuts out when running for fairly long period of time. Wait 30-40 secs and it goes again. You can run it all day small amounts of time but try to go across to another dock or channel any distance and it cuts out/then comes back on after waiting. Is it getting hot? Sounds like a switch...
  14. S

    Eagle FishFinders

    I was reading a post on interference between two eagle finders of same frequency. My question is I have a Eagle 168 on the bow and Eagle FishElite 480 on the console if I have the console unit on just for mapping is it constantly "pinging" even if not using sonar features at the moment? And if...
  15. S

    lower unit leak 1997 Johnson Ocean Runner 150

    thanks to you folks my previous post about slipping/cavitating seems to have been solved. However, in the process i changed the lower unit lube and noticed it to appear milky or at least the color of mustard. I dont think there is a lot of water getting in and not real sure where to look? I am...
  16. S

    Johnson slips/cavitates after 35 minutes

    I have 1997 Johnson Ocean Runner 150 hp. It will run like a champ as soon as you put it in the water. After about 35-45 minutes it will shake/hesitate/cavitate/slip or something im not sure. It will only do it about 4000 RPM and if you decelerate its fine. Im not sure if cavitation or what but...
Top