Search results

  1. 79Invader

    Gas gauge question

    Hey guys, hope you’re staying safe and healthy. Anyways I went to take my boat out and noticed the gas gauge wasn’t working, was on E (I just filled it up last week when I went out last). I popped the sender out and cleaned the contracts, still same issue. I tested the gauge my shorting the pink...
  2. 79Invader

    Mercruiser 5.0 losing RPM

    Hello. My 1990 mercruiser 5.0 throttles right up and gets on a plane just fine. Runs about 40 mph at 4600 RPM. After about 60 seconds of running wide open it starts to lose RPM’s. Once it’s down to about 4000 RPM there’s an audible “clatter/rattle” coming from the motor. Throttle down and idle...
  3. 79Invader

    U-joint bellow popped off

    Hello guys I have a 1990 sea ray with the 5.0 mercruiser. I unwinterized it and noticed the u-joint bellow has popped off the transom side. Is it possible to slide it back on and tighten the clamp without paying someone to pull the outdrive? Anything else I should know? I’m not very familiar...
  4. 79Invader

    115 hp evinrude won’t throttle up under load

    I have a 1979 115 hp evinrude that came on a project boat. The motor fires up without much hesitation, and seems to run great out of the water on the muffs. Revs good in gear and doesn’t sound like it has any misses. In the water under load, it doesn’t plan the boat (16 foot tri hull) in under...
Top