Search results

  1. C

    Lost key

    I have an old pontoon boat with a 1979 75hp Evinrude motor. I have lost the key to the boat and I am trying to sell it. What would be the best way to get a new key? TIA Barry
  2. C

    Carb parts question

    I have a 1979 75hp Evinrude outboard that I had taken from Arizona to Colorado and had to change the 3 carb jets to ones for a higher altitude. Now I am back in Arizona and was changing them back to get the boat ready to sell and the jet in the bottom carb has been stripped. I have a mechanic...
  3. C

    What control replacement

    I have an old pontoon boat with a 1979 75hp Evinrude. I would like to replace the engine controls mounted to the pedestal with a new setup as the old one is very worn out. What would be a good replacement? Barry
  4. C

    Looking for a part.

    Problem is I have is '79 75hp Evinrude boggs after moving boat from AZ to CO. Ran great in AZ but boggs when throttling up. Idle is ok. Have replaced fuel line including primer bulb and filter with no change. Squeezing bulb while bogging make no difference. Curious if the motor should be...
  5. C

    Parts for pontoon railings.

    I have a 1980 18' Kayot pontoon boat that I have been replacing the wiring, deck boards and carpet on. This boat had a swim deck up front with swim rails. The old ones were not holding well and kind of tore up. I am having difficulties finding the mounting hardware for the swim rail online...
  6. C

    Looking for part for tilt/trim

    Back on 4/22 I asked for assistance with my tilt/trim motor on a 1979 75hp Evinrude. Someone suggested that the Arco 6206 would be the correct one. Per the SELOC manual I have there was a unique single ram system used on some v4 units prior to 78. The diagrams of this fits what I have, so I...
  7. C

    79 Evinrude 75hp outboard with tilt/trim.

    While going through and replacing the deck/carpet on my 81 Kayot pontoon boat, I thought I would replace wiring. The worst is the tilt/trim wiring. The 3 wire cable comes out of the top of the tilt/trim motor but while inspecting it at the motor and taking the top plate off the motor, the...
Top