Search results

  1. M

    1999 Honda BF115 bell housing full of oil

    Hi all, Looks like I’m going to be pulling my power head to replace some seals (see attached picture). Seen some oil around my starter so I decided to pull and inspect. The bell housing is full to the brim with oil. I have a good manual, doesn’t look like too bad of a job. Just wanted to start...
  2. M

    1999 Honda BF115 intermittent long alarm no MIL

    Hi all, Have a 1999 Honda BF115 BZBD-1000320 with an intermittent long alarm. No MIL light or alternator light on. Shorted the harness to see if any codes come up but get nothing. Swapped the pins on the battery and MIL lights to verify it works and it does. Motor starts and runs great...
  3. M

    Honda BF115 power tilt relay wiring

    Hi all, My power tilt relay has corroded to near dust (see picture). The price of a new one has me at least wondering if it is possible to wire two typical relays rather than spending the $450 the dealer wants. I have attached a picture of the wiring diagram from the manual as well. As you...
  4. M

    1999 Honda BF115 power tilt relay

    Hi all, My power tilt relay has corroded to near dust (see picture). The price of a new one has me at least wondering if it is possible to wire two typical 5 pin relays rather than spending the $450 the dealer wants. I have attached a picture of the wiring diagram from the manual as well...
  5. M

    Honda BF115 seized from sitting

    Hey all, I just picked up a Bayliner with a 115ho Honda. Motor ran when it was parked a couple years ago. It seized up while sitting. I’ve freed up old Chevy I/O motors using some trans fluid in the cylinders. I was hoping to do the same thing with this motor. My current plan is to soak it for...
  6. M

    5.7 Vortec with Edelbrock 1409 Carb Jetting

    Im just finishing up the re-power in my boat from a 4.3 to a 5.7. I have the Edelbrock 1409 carb with the stock jetting that comes with it for the 5.7 non vortec (removed the calibration kit for the 4.3) I did a plug read and they are looking very lean, still white. Im wondering if anyone on...
  7. M

    Merc 5.7 idles and then stalls

    Hello everyone, Im having a idleing issue with my boat. I have recently re-powered with a 5.7 vortec reman from atk. The issue I’m having is when the boat is cold it starts and idles for maybe 5 mins. Once warm it will run rough and stall. I turn the key off then back on, crank the motor...
  8. M

    Mercruiser 5.7 overheating at idle

    I have a 1994 stingray 719zp that originally came with the 4.3 mercruiser. I have re-powered this summer with the 5.7 vortec long block. Everything is new, water circ pump, impeller in stern drive, intake manifold, exhaust manifolds, risers, thermostat housing with 140f thermostat, sensors in...
Top