Search results

  1. Xcakes0X

    1972 Johnson 25 Rough Idle

    Hey everybody, I got a 25 Johnson that spits and sputters at idle and sometimes likes to die at idle. Sometimes it seems like a "lean sneeze" but when I adjust the idle mixture and richen it until the motor dies the coughing never disappears. The motor only does this when it gets warmed up and...
  2. Xcakes0X

    Sea King Serial # location

    So I got a 7.5 chrysler made sea king from 1984, I need the serial off it but the plate where the serial was on the outboard mount is broken. So I was wondering if there was anywhere else the serial number was located on this outboard?
  3. Xcakes0X

    Removing water pump housing problem 1983 7.5 chrysler

    So I’m doing an impeller change on an 83 Chrysler sea king 7.5 and I can’t figure out how to get the water pump housing off because it surrounds the shifting rod which starts to curve so I can’t pull the housing straight off. I am wondering what I have to do in order to get the housing off, I...
  4. Xcakes0X

    ‘83 Chrysler 7.5 No spark

    So I’ve been working on an ‘83 7.5 Chrysler with no spark on either cylinder. I went ahead and replaced the stator, trigger, and the cdi/ignition coil. I’ve checked all grounds and disconnected the kill wires to avoid the kill switch. Even after all this I still have no spark any ideas as to...
  5. Xcakes0X

    ‘83 Chrysler 7.5 replacement follower for carb throttle linkage

    So I’ve been working on a ‘83 7.5 Chrysler and noticed the black plastic cam follower that helps move the throttle linkage on the carb is broken. Part number is F525316-1 but the problem is they don’t make em anymore. Does anybody know what I could do to fix this? I am providing a pic below
  6. Xcakes0X

    Chrysler 7.5 no spark

    So I bite the bullet on that Chrysler 7.5 I was looking at. Found it has no spark, I’m not familiar with Chrysler outboards so any idea what could be the problem? It has no spark on either cylinder so I doubt the coils would be the issue.
  7. Xcakes0X

    Serial # location on Chrysler outboards

    I am looking at buying a Chrysler outboard but the serial number plate on the bracket with the serial number is faded. Is there anywhere else to find the serial like on the engine block?
  8. Xcakes0X

    69 Evinrude 6Hp correct spark plugs

    So I am almost done on working on an used 6hp evinrude fisherman I bought and I need for it a new set of spark plugs. I’ve found two answers online for what plug to use. The original manual says to use a champion j4c but people say online a j6c will work. I would rather go with the j6c if I can...
  9. Xcakes0X

    ‘69 Evinrude 6 Shifting Rod connecting problem

    I have a ‘69 evinrude 6hp I replaced the impeller in. When trying to insert the shifting rod off the lower unit into the connector that connects the 2 shifting rods I can’t get the lower unit shifting rod into the connector enough without making it so I can’t get my screwdriver in there to put...
  10. Xcakes0X

    1969 evinrude 6 impeller size

    I got a used 1969 evinrude 6hp and decided to change the water pump in it. I looked up the part number (0277181) and ordered one. Once I got the impeller housing apart the old impeller and inside the housing was much smaller than the new one and the new one couldn’t go down over the old impeller...
Top