Where can I find this part ? Mines toast I do believe, I think it’s the prop bearing cage, also how do I install the new seal I got, the forbidden screw on lower unit that connects to control rod
Hey I was trying to pry control shaft seal out and my lunch tip broke off and I’m unsure if it fell in, I have spun gears and don’t feel any binding , any tips ? Was told never to remove screw on back and I think I have to to gut gears
I need a recommendation on where to find two control cables that match these or would work, and how hard is tuning and hooking these suckers up , thanks in advance
Could a bad thermostat cause the engine not to **** out of the exhaust ? And where is everyone sourcing the replacement gasket and thermostat at 1990 force 50hp
How would I go about replacing the seal on control rod shaft because previous owner rtv siliconed it and when I pulled lower the rubber boot to driveshaft and ring wasn’t on it but upon further inspection the boot was just inside and I can’t locate the copper ring , my hands are to big to fit in...
