Search results

  1. 2

    bravo bellows job, design #2 water intake hose question

    im doing bellows on a bravo 3, the water intake hose has the plastic section going into the housing and the rubber hose has a clamp connecting the 2, one of those crush squeeze clamps you see on non reusable items can i/ should i cut the clamp off and install a new rubber hose or is it ill...
  2. 2

    why is there oil in my bellows but pressure test holds 15psi overnight

    i pulled the drive on my boat and there is oil in the bellows, lots of it. i drained and pressure tested the drive and find no leaks. could the drive be overheating and pushing the oil out of the input shaft seal? bravo3 drive,
  3. 2

    2009 4.3 gxi-j cant get it over 3k rpms

    i have this boat that will not get out of its own way. and its kicking my ass, i hope someone else has had a similar issue. it feels llike i have 6 fat guys sitting in the rear of the boat. the engine has 150hrs on it, the fuel pump module was replaced due to low pressure and noise, the screen...
Top