Search results

  1. L

    Water pump metal cup

    Yet another silly newbie question. How do I remove and replace the metal cup in the water pump housing? 20 HP rude, 89 model. Thanks so much for the help.
  2. L

    Old 'Rude got me again

    Two questions. It is a 89 25 HP. I started a topic earlier, now this has changed. Water pump impellor, the vanes were pointing in opposite directions and did not work. What did I do to cause that? I rotated the housing when I installed it, it never pumped. The drive shat move up from the...
  3. L

    Short shaft adapter

    I bought a boat that uses a long shaft motor. Is there a way to use my short shaft 9.9 as a kicker?
  4. L

    '89 25HP Evinrude water circulation

    I'm beat on this one, I just got the motor running great. I took it out for a day on the lake, ran fine for about an hour. I noticed the tell tale stream getting weak, as I went to shut it off the motor the stream quit, I trolled back in. When I pulled the impellor it looked ok, I put a new...
  5. L

    Water Pump Blues

    My 89 25 HP Evinrude's water appeared to be failing on the lake, went from stream to trikle. I put muffs on at home no flow.<br /><br />Installed new water pump. It don't pump either, I watched the water tube start in the pump. I lubed the pump parts and double checked everything. <br /><br...
  6. L

    Attaching lower unit

    I have a 89 25 HP Evinrude. I changed the water pump, now the problem. The lower unit is about 3/8" from contacting the exhaust housing and will not move further. I rotated the flywheel the driveshaft feels engaged, I saw no damage to the splines and everything came apart easily. I could see...
  7. L

    25 'rude idle

    My 89 25 HP rude has a small idle problem. It idles smoothly then sputters and dies. Runs great anywhere above idle. I ran it from just off idle to full throttle for about one hour in a lake, moving boat. It only has this happen at idle. New plugs and 120 PSI on each cyclinder. Plugs...
  8. L

    Replacing decals

    I have an aluminum boat with old factory decals. What is involed in replacing them?
  9. L

    Two questions prop and plugs

    I have a 25 Evinrude. The prop only clears the skeg by 1/8 inch. This is a approved prop by Evinrude, anything to be concerned about? I have 120 PSI compression on both cylinders, but on one the plug is wet and black the other is wet and clean, new plugs and motor runs good. Again should I...
Top