Search results

  1. H

    Lubedude decarbing

    decarb way Roscoe had posted Nov.(decarbing your engine) I used Quicksiver power tune.<br />have old manual Clymer 1991. off to get new Seloc manual, this is going to be fun working on this one. thanks hardtime :(
  2. H

    decarb lost #2 cyl

    Rude 150xp/1990 would not run to 5500rpm low on #2, decarb now #2 has 30psi all other 90psi<br />before #2 had 60psi. ? can i get the leaf stop & leaf valves with out hold rebuild kit. need good<br />parts brake down of motor. :(
  3. H

    want make 5500rpms

    1990 evinrude will not run at 5500rpms in wot. carbs. rebuild two times this year,new fuel lines from carbs. to tanks.Orifices, needle valves & seat assembly clean & check ok.<br />boat gets on plane ok move leaver to wot trim<br />to little over half plane, all i can get is 5000rpms & 50mph...
  4. H

    XP150 spits & stops

    1990 evinrude xp150, have cleaned carbs.and<br /> decarb.(taken carbs. apart and cleaned in <br /> side)motor starts, but have to push chock<br /> alot because it spits & stops. when it idles<br /> for awhile it runs at WOT, it runs good <br /> when slow to idle. The rpms at high...
  5. H

    To Clanton (Admiral) 150xp orifice

    My mistake Admiral, year 1990 xp150<br /> Getting old turn 51 this month. Hope<br /> thats the only thing to go!<br /> Have to get model # Tusday,<br /> <br /> thanks hardtime :(
  6. H

    Evinrude 150xp orifices

    1980 Evinrude 150xp that has three Tri-Jet<br /> carburetors. That would not run at wot,<br /> had carbs. apart and Clean the orifices<br /> out now runs good. The orifices in it had <br /> 30c on them,the manual has at sea level<br /> on high speed use 49c. I am at 760 above<br />...
  7. H

    Manual to elect.

    Question> Can i put elect.start on a Merc.<br /> 9.9 the year may be 1987 model? Is there a <br /> fly wheel with starter ring on it?<br /> :confused: <br /> hartime
  8. H

    evidrude xp150 high speed miss

    1990 evidrude 150 that starts fine,idles fine, runs up to 4500rpms fine, from 5000-5500rpms<br /> it starts to miss or skip some times bad. go back to 4500 it does ok. carbs. rebuild last spring,<br /> replaced fuel lines from tanks,to motor. the rectifier was also replace. did fine water leak...
Top