Search results

  1. D

    20 HP Evinrude

    comes with a new to me boat and had a big crack in the lower gear case. Its a 1989 20 hp Evinrude, manual start. I need to replace it. I have been looking to replace it with no success. Now I have to widen my search for other year model that would be compatible. Can anyone tell me what year to...
  2. D

    2010 Merc 9.9

    New motor(manual start) having issues. It has the forward, neutral, reverse shift on the gas grip throttle/handle. Last week, it worked great all day, then, it will not start anymore. Gas tank is full, vent open, prime bulb ok. Ended up rowing the boat back to the Park and it sat there...
  3. D

    honda 9.9 starter question

    used to start right away and run all day no problem, then one day, it will not start via the starter, though I can get the motor started manually with the pull cord. Tried the starter and nada, does not even spin or no audible click. I know the battery is on the weak side. Could it be due to...
  4. D

    tilt problem 03 ox66 150 hp

    Please advise. I've searched the forum but I have a unique problem with my tilt trim. Here goes... My tilt trim motor filled with oil, removed the trim motor and just replaced old seal with new seal. Dried up the motor winding, installed new brushes. Bench tested the motor and it was running...
  5. D

    tilt problem 03 ox66 150 hp

    Our boat is not near anywhere and no trailer available at this time. Therefore, I have to do my own troubleshooting. I noticed recently that the tilt/trim has started to slow the raising/lowering of the outboard and finally it will not work anymore. I can hear a clicking noise at the engine...
  6. D

    multi tach installation

    I'm replacing the faria tach that was original to my boat with the Yamaha multi function digital tach. My question is: where do I set switch 2 (generator type) for 2003 150 OX66. I've searched the forum for the gen type for my motor, but coming up with no result. It seem the replacement is...
  7. D

    tach showing higher than engine rpm

    '04,150 ox66 tach was ok last week. Yesterday, I noticed the tach was pointing at 1500 rpm at idle but I know from the sound of the engine, the rpm is much lower. I'm using 19p prop and my max rpm on it is 5500 rpm, now shows around 6500 to 7000. The engine runs fine and I kept the engine...
Top