Search results

  1. F

    15 hp. short shaft Motor #OA757313 need lower unit

    need a lower unit -what years will fit ? 2 cycle the- lower unit is missing thrown out by seller
  2. F

    86 islander 4 cylinder bell housing question

    the rubber end cap that is held on by a big radiator clamp. It is above the starter right by the motor mount. It is shot and needs to be replaced. engine model 2526THRCRAA Engine serial.#J815044.On opposite side is where exhaust goes into it. I can't find it anywhere. what is it called part #...
  3. F

    86 islander 1901 cuddy doors

    Has anybody reversed them to open inwards. That step down is hard on my bad back. That way I could cut the depth in half. I think I could take frame apart and install from the outside. Thanks Ken
  4. F

    86 starcraft islander 1901- transom

    Yep, a stringer too. I took the transom seal off (22 hole rubber) I noticed the lower part of plywood was mush. I plan on taking the bad out and replacing it. The stringers on this are all aluminum. so no problem there. I am hoping I run into good wood 8 inches or so up.I will replace it and...
  5. F

    Blower vent line I/O

    Can I use aluminum dryer vent line.
  6. F

    19'1 islander- I/O aux. power

    Getting it ready for the water. Have a OMC aux motor mount to be mounted. Where at on stern ? What horsepower would be the best? What ever you do don't believe the genius part! Ken Transom seal to be replaced too. Carb yet to be done. Fuel tank drained , will add shut-off valve and extra...
  7. F

    2.5 OMC stern drive rubber boot torn

    Numbers off engine 252STHRORA and J 815044 Numbers off stern drive M 983486 SN J340230 The big rubber boot is shot on stern drive. Will have to be replaced. How to do? Is there a sticky to follow? I do not have a repair manual. Thanks, Ken
  8. F

    5 hp Buccaneer 5D11B 566234 1955

    Length of plug wires from spark plugs to where they go in on right side. Mine look real long but maybe they are suppose to be that way. I know they have to move with arm. plate or whatever. Nice running motor with full gear shift. I am using a 24-1 fuel mixture with a small inline filter...
  9. F

    1972 9.6 sea king

    throttle is jammed on fast- last time I had it out throttle was sticking -- how do I free it up. I sprayed PW Blaster on linkages no help yet! Have carb off and soaking for cleaning,it needed it. Hasn't been run since last year.Ken
  10. F

    1955 Gale 5 hp

    5D11B 566234 Ran good, had sprayed with Deep Creep once . Took it out yesterday ran good for a mile or so than cut out. Restarted after a minute or two and ran very well but for a shorter distance kept on doing it but shorter runs each time. I didn't have cover off at the time and mosquitoes...
  11. F

    33 ski-twin 1968 flywheel off

    Last year I took it out once,no power to speak of Ran good in barrel; one dead cylinder no spark. Now just got the flywheel off ok used H.balancer tighened it and smacked it with a big rubber mallet. Now how do I find out which coil is bad or in other words where my problem is. I don't even...
  12. F

    72 9.6 seaking vwb 27209 27x21364 fuel pump

    I put a gasket repair kit in. The reads were corroded up -I cleaned them up in process bent one. I straightened it as best I could and flipped it over and put it back in. Seems to run alright but would like to replace both reeds. Where to find them?? they did not come with pump repair kit...
  13. F

    Johnson 15 hp yr and what spark plug

    FD-15F Sr#2189741. Thanks Ken
  14. F

    33 hp 1968 evinrude 33852R-E 01834

    Ran it was glad to make it back to Dock. Ran good in tank I thought..Dead cylinder Used spark tester one very good spark the other nothing at all. Motor new to me Have a cd manual . Is there a good thread on getting to the coil etc. If one is bad should I replace both. Will change points at...
  15. F

    5 hp x52F9A X1586 Has N& forward

    Lower unit vent screw -there is small screw 2-3 " above prop hub and way up-a ft. or so a rubber oblong plug on lower unit.I am afraid of taking screw out until I find out if it the right one. Feel more like the Finnish Jackass today. Think the screw has to be it... edit- forward and neutral...
  16. F

    faded paint on motor

    any way to brighten it up. brillo pads etc ????? buff it out-how ?? any ideas Ken
  17. F

    old 2 cable steering

    how to put cables back on wheel?? Diagram or pictures or other thread on this?
  18. F

    Evinrude 4429 01176

    Would like yr and hp I think it is a 5hp. 2 plugs to a cyl. 2 cylinders. Hasn't run in yrs. I don't remember even running it. I know gas tank has alot of varnish in it. All the lines and carb will have to be gone thru. I bought it yrs ago from a friend at work, it was his Dad's outboard. Ken...
  19. F

    E10rlctr F194454

    tried to look it up for my buddy. no can do-can anybody? thanks Ken E10RLCTR f194454
  20. F

    old cable steering to tiller

    33 hp ski-twin 33852R E01834 Electric start. Thinking of going to tiller steering. Has no tiller handle. Was thinking if I could leave the throttle and shift where it is and use tiller to steer. Main thing is to get motor going and see how it runs. It is on a old starcraft tri-hull. Long shaft...
Top