Search results

  1. V

    shift coupler?

    ran boat this weekend and stopped off at an island for a short time, pushed boat out and got underway with no problems untill trying to dock and found i had no reverse... can go into forward but no reverse, just changed lower shift cable and bellows 2 months ago. jumped in water and felt...
  2. V

    goes out of gear in the turns

    just replaced my u joints, gimble bearing, lower shift cable (shifts f and r just fine) and all three bellows on 83 mercruiser 260 with pre alpha one drive. everything seems to be working fine, no more noise from gimble bearing (low growl in turns), and u joints where making noise in hard...
  3. V

    no fuel getting to carb...

    just changed fuel filter and water separator filter, boat was running fine untill now. 1983 mercruiser 260 5.7. pulled fuel line from carb and turned motor over and no fuel. mechanical fuel pump, so i dont think there could be a fuse issue. going to buy new fuel pump tomorrow. any help...
  4. V

    torn exaust bellow

    exaust bellow is torn and the others are about to. I am going to teardown and replace all three bellows, the u joints and the gimble bearing while im at it. can anyone suggest the best manual to buy? 1983 cenutry with mercruiser 5.7 260hp. thanks.
  5. V

    merc 260 goes out of gear

    first time here so any help is appreciated. I have a 1983 mercruiser 260 recently having overheating problems, changed impeller and waterpump so i would not have to go back for awhile. boat idles fine (runs at 140degrees at idle) but gets hot fast under load above 3000 rpm for short time...
Top