Search results

  1. S

    1984 Johnson 70 Tach Issues

    I have a 1984 Johnson that i have had quite a bit of new electronics ie ignition module, timer and base etc.. basically everything except coil packs and the recitifer is new (within the last 6 months). i rebuilt my 1984 Tracker and when i did it i replaced the gauges with a new Faria Tach. it...
  2. S

    1984 Johnson 70 hp No Spark

    my father purchased this boat a few months ago and the boat had a bad ignition module. we replaced it with a new OMC CD3 ignition module and boat has run fine the total three times he has used it. probably less that a hour or maybe just over a hour on the module. we put new plugs in it at time...
  3. S

    1990 90 hp force ignition problems

    well i bought a used boat and it has a 90 hp force engine. it had compression and appears to be getting gas however after inspection for spark i only get spark on coils for cylinder 2-3. i thought bad coil but decided to try it connected to other cylinder cdi wire and it works. so now i am...
  4. S

    1995 120 hp force low compression

    i have a 95 hp force that has 10psi in to cylinder but runs fine. starts right up and makes no noise. any idea on where i should look first to fix problem. thanks
  5. S

    96 115 hp evinrude overheated

    i bought a boat that the motor overheated. it is a evinrude 115hp i am pretty sure the guy did not pay attention that the waterpump went out. so i know i need to fix that but where should i start to find out what else maybe wrong with the motor? thanks
  6. S

    1985 25hp evinrude

    well i have a couple of questions. first i must say that 20 years ago i became an omc certified outboard mechanic while i was in school i did this for about 5 years and haven't used it since. however i recently bought a 25 hp evinrude that had been dropped and broken the lower engine case. i...
Top