Search results

  1. N

    volvo trim

    I have a 290 duo prop leg and have just started having a problem with the trimming it will come up but wont go down to get it down I have to release the hydraulic fluid once this is done it goes down.<br />Today I have power coming up but no sound from the pump to go down. So again release fluid...
  2. N

    Duo Prop wanders

    I have a 24foot fiberglass centre cab with a mid mounted steyr diesel with hydrolic steering the boat wanders terribly at low speed i am constantly turning the steering wheel to keep it in a straight line, the leg is a volvo290 with duo prop?
  3. N

    Fuel injection for Volvo AQ271

    Hi Guys<br />Does anyone make a fuel injection for the AQ271(basically a 350 Chevy) Has anyone replaced the carb with a set up and can recommend one.<br />Thanks Nick
  4. N

    Stainless risers for volvo

    Can anyone help with the best place to purchase stainless steel exhaust risers for an AQ271 Volvo Penta. Mine were replaced in 1998 they boat is used exclusively in salt water but flushed out with fresh after every trip. But I am worried after reading a number of posts with regard to corrosion...
  5. N

    Volvo Penta Steering Yoke

    Hi Guys I have just dismantled my steering yoke after losing steering completely at sea.<br />(AQ271 WITH DUO PROP LEG)The splines on the yoke are completly worn away. Can these be rebuilt or are they a throw away job. Any sugestions much appreciated.<br />Nick :confused:
  6. N

    volvo penta duo prop manual

    I have just purchased a boat 23footer GPR centre cab with a AQ271 Matched to a duoprop. I did not get a manual with it the motor or leg can any email me a breakdown of the leg as i have to replace the exhaust rubber tube as it has been sliced, Does it hurt to run it? I intend to replace it...
  7. N

    Shimano tts 30

    Does any have a parts catalog you could scan and email to me as i have serviced my tts 30 and cannot now locate where two washers go. I did not dismantle the drag only took the plates off but i do know where these two washers go. They are about 10mm in diameter with a 5mm hole????<br />I have...
Top