Search results

  1. S

    1992 150hp Evinrude Elence Wiring Question

    Hello, I replaced my engine harness and have a couple of questions. I have close to the bottom two wires that I cant find any connection to . Everything else color coded back together fine. I also noticed the inline fuse seems to be bigger than original ( length wise). would anybody know what...
  2. S

    checking the rectifier on 1992 150 evinrude spitfire

    How can you check to make sure that the rectifier is bad with a voltage meter? ( I only have the cheap harbor freight one) this is what I found so far. the red had power no matter what and the purple wire only has power with the ignition is on and the gray wire doesn't but haven't done the test...
  3. S

    1992 150 evinrude e150elence question on charging

    Im sure this is dumb question to ask but went through dead battery issue. it sat for two weeks and the only thing I know that would pull a charge is the stand by with the radio but nothing else I can think of but threw battery charger on it for about an hour not knowing at the time if the...
  4. S

    Question on plug plug line on rear of motor

    This is something I have seen done on other motors but the question is why? Its on the rear of the block. I cant find my manual to research it and don't know what exact name would be used? I had a older mercury motor that it too had been plugged up.
  5. S

    Fuel leak on top part of fuel pump

    I am back again with a fuel leak that squirt under pressure. I know its the square O ring style on my 1992 150 Hp Evinrude Elence. It has four screws but one in the back corner isn't accessible other than I remove PUMP AY,VAPOR out of the way but then I am thinking I would have to get another...
  6. S

    Low idle is rough

    Hello, I have a problem with idling. it will run and sometime dies eithr on its own or when I put it into gear. it kinda jerks/rough idle. I took all the carbs off one at a time and thoroughly cleaned them with carb clean and air so I am pretty much sure upon looking that they are cleaned. I...
  7. S

    1992 Evinrude 150 hp Squirts gas

    I have a 150 1992 evinrude that when you are starting the motor, the choke squirts out fuel. it looks like a valve stem that has a red lever. it loosen or tightens but my question is if there's a rubber seal that may be going bad and is it something I can replace? it only leaks when starting the...
  8. S

    Custom Cabinets Built

    EDIT: Please read the posting guidelines.
  9. S

    Apelco loran/gps model 6700

    Im looking at one these and the person is asking 75.00 dollars for it. being new to buying gps and just trying to find one to have till I can get a newer one. I need to find out is it worth the price and how good is this model? what do I need to know about it. just general knowledge questions...
  10. S

    tilt and trim clicks but doesnt work

    I started the day with a problem with my T/T. I went out there to raise the motor to trailer to the dock. it started going up at a slow place but acted like the batteries may have been going dead and it stopped. now I did a check on the batteries and they showed 12 volts. since my meter is a...
  11. S

    150 hp 1992 Evinrude Spit Fire question

    OK, I'm going to explain my question the best I can. Maybe someone can help me with this? on the fuel pump ( fuel and oil pump) on the top there is something that looks like a valve stem with a red lever that you can release what seems to be pressure. I have noticed that my motor doesn't like...
  12. S

    Swapping lower unit

    I want to know if you can swap a 1976 Mercury 650 with a mercury 1976 850?
  13. S

    Trim Tabs Questions

    I have a question on trim tabs. since my budget is so strict, I have looked on ebay for a deal on trim tabs. since people are bidding goofy, I have looked for better price in the buy now but I don't plan on buying till I have the money and know for sure what I am buying. I found this type with...
  14. S

    The bracket that holds both cables

    I have a 1992 150hp Evinrude Spit Fire that even with a manual, I cant find a name of the bracket or a parts number. it the one located on the left side of the motor where you throttle cable and gear selector comes into the motor. when I ordered new parts seeing that all of the parts were...
  15. S

    Hummingbird gps reciever

    I have a crazy question. I bought a hummingbird receiver that will go the the hummingbird fish finder/gps system Im getting next for it. I couldn't afford both at one time and they only had one left. anyway, I have a Standard Horizon Eclipse Dsc GX1000S that I was curious if I could hook it to...
  16. S

    Battery switch

    Being not sure on some wiring I must ask this so that I don't do the wrong thing. I bought a battery switch to run dual battery's . the wiring diagram is so small that its not the best to read. you have positive 1 and 2 which are for each batter and you have the common which is where I am...
  17. S

    Tach issues

    Ive been trying to hook up the tach but no luck. I was told the gray wire but when hooked up nothing. did a test light and it shows nothing. there is power going into it but not either way from the gray wire. its a 150 Evinrude soit fire motor. theres only 3 wires from it. one goes to a power...
  18. S

    Question about oil injection Tank

    I'm getting mixed opinions about the vro oil injection on my 92 Evinrude Spit Fire 150hp. I got the motor without the tank so I bought one. it has the oil injection pump on there so it was easy to hook up but the sensor wire has been the question I was asking about since I can not locate where...
  19. S

    Evinrude 150hp water temp question

    I have a 1992 Evinrude Spite Fire. I start the motor and it peeing fine but the water temp seems hot to me.My first thought was the thermostats and took them out. I took a pot of water and heated it up and drop them in there and they reacted so I'm sure they are working. if its peeing and the...
  20. S

    Evinrude oil injection

    I have two questions. 1) I just bought a oil injection tank for my 92 150hp evinrude spit fire last week. I went out and bought the manual thinking it wouldn't be a hard job but the book tells me to have it done by a mech, so I went online to see what else I could find in pics for this deal and...
Top