Search results

  1. 9

    I need some input on a 1991 Yamaha c115tlrp

    special test equipment is needed along with the specs in you service manual to compare the readings to
  2. 9

    I need some input on a 1991 Yamaha c115tlrp

    if there is no spark ,you need to measure the voltages into and out of the CDI
  3. 9

    I need some input on a 1991 Yamaha c115tlrp

    have you tested for spark when #1 was not firing?
  4. 9

    Suzuki df200ap 2021 outboard thermostat

    and still you have not answered my question about if the motor is running to heat things up to open the stat while you are flushing with fresh water. or maybe that yes was confirming you do run the motor while flushing
  5. 9

    Suzuki df200ap 2021 outboard thermostat

    still no answer to this question
  6. 9

    Yamaha 9.9 troubles

    compression is easy to check, and a carb clean & pulling stat and flushing the cooling system with something like Ridlym marine descaler is not that hard either
  7. 9

    Suzuki df200ap 2021 outboard thermostat

    is that with motor running to get the stat open and fresh water circulating thru the open stat?
  8. 9

    Suzuki df200ap 2021 outboard thermostat

    do you ever flush with fresh water after running in salt?
  9. 9

    Need help with ID

    how about the carb
  10. 9

    1992 yamaha 2-Stroke 85hp tiller handle lower unit

    I guess you have a leak even with a new OEM oring. are you sure the surfaces are not pitted or damaged. or maybe the oring got damaged during installation. Sorry, I have no idea where you could find an oversized oring
  11. 9

    Suzuki oil change warning question

    so you tried doing the procedure after doing the oil changes and that did not reset the hours for the alarm? did you try contacting Suzuki to see what you could try?
  12. 9

    Suzuki oil change warning question

    I would think a owners manual or service manual for that motor would tell you how to reset the timer after an oil change. Just like they do for automobiles.
  13. 9

    1990 vs 1996 9.9hp 4 stroke cylinder head/ gasket interchange?

    heck if you have both ,why not try it to see if it works OK
  14. 9

    Yamaha 115 anodes

    only way I can think of is to open it up to inspect and/or replace
  15. 9

    Yamaha 115 anodes

    Look in your owner's manual for when they say those need to be replaced.
  16. 9

    Stator issue ( I believe )

    Yeah, I always start with compression, spark, and spark timing If all of that is good then chase fuel. maybe he already narrowed it down to spark problems
  17. 9

    99 3.1l ox66 wont rev (what am i not thinking of here)

    thanks for the update
  18. 9

    Power trim stalling motor (hpdi )

    well I sure sounded like you were pointing at the 3 amp draw of the T&T relay you mentioned, and that relay was working fine "In summary, the control mounted PTT switch needs to pull about 3A of power thru the 25-30' boat harness twice, to energize the PTT relays. You might use an ohmmeter to...
  19. 9

    Power trim stalling motor (hpdi )

    he said they both raise and lower the motor ,but the one on the control causes the running outboard motor to mess up. Not the T&T motor
  20. 9

    Power trim stalling motor (hpdi )

    that does not make sense to me. Does the T&T work from both switches? You might try to measure the battery voltage while hitting each of the switches to see if there is a difference
Top