Search results

  1. S

    1979 merc 40 horse

    Bought a semi basket case for my john boat, does anyone have fuel line hose diagram from fuel pump? Looks like water runs thru part to tale tale , but not sure where fuel lines go, the way I thought can get fuel to motor, and check valves can only go one way , so they cant be rev, one one way...
  2. S

    shift cable and bellows

    got boat in , after all the help I got from this forum ,replacing engine , gimble etc,, , must of did a good job with alignment as it fell out, to the question , seems I have the dreaded shifter cable problem, shifting in and out of reverse and now forward , dies, 95 merc 4.3 alpha 1, ser no on...
  3. S

    85 mercruiser outdrive spline same as 95

    can get a good deal on a lazer 2 prop , guy said he had it on a 85 305 merc , mine is a alpha gen 2 , will prop work?
  4. S

    98 4.3 Valves

    Can You Just Tighten Down To 22 Foot Pound And Go Or Adjust Them?
  5. S

    4.3 alpha outdrive alignment

    up and down is great with alignment tool, starboard side drags, in my mind i need to raise port side and lower starboard ? has new gimble bearing and new motor, orignal rear mounts only have 300 hours, also i found use a little bluing helps to see better than grease. :confused:
  6. S

    4.3 4b 9600s 1995 vintage

    got new motor in boat , rebuilding carb used a edelbrock kit and used a 1485 tunning kit, my question is can i add a electric choke to this carb? i changed to vortec heads and got new intake, mercruiser, the old intake had choke stove in intake that operated chock. or go with no choke ,thanks...
  7. S

    4.3 4b 9600s 1995 vintage

    got new motor in boat , rebuilding carb used a edelbrock kit and used a 1485 tunning kit, my question is can i add a electric chock to this carb? i changed to vortec heads and got new intake, mercruiser, the old intake had chock stove in intake that operated chock. or go with no chock, thanks...
  8. S

    95,96 Flywheelcovers The Same 4.3

    Just Finishing Up My 4.3 Merc, Installing Flywheel Cover, The Newwer Block And Oil Pan Are Differnt Then 95 Do You Still Use The Tin Down Below, Did A Lot Of Searching, Book Shows It But Is A Clymers , Really Dont Trust It Thanks Again Tim
  9. S

    4.3 with vortec heads

    just got my engine back together , install vortec heads and new intake , will there be any issues with carb as far as running lean ? its a 95 vintage with thunderbolt ignition, also how to time whens theres only one line on dampener ? thanks tim
  10. S

    95 crownline 4.3 bad block

    bought a 95 crownline 4.3 , very low hours, they did not winterize , tore apart cracked both sides by oil gallarey, internals look brand new, which s10 block will work? casting no 16227196 merc ser no of587082 heads are 10238181 ao55 and ao45 timming cover has 10 bolts pan has 12 and 4 studs ...
Top