Search results

  1. F

    Internal/External Truarc Pliers???

    I'm going to be disassembling my 115 Evinrude lower unit. What type of snap ring pliers do i need. I see some that are 8" or so on ebay. Are they long enough? Also do I need internal or external? How far do they need to extend?<br /><br />Thanks in advance,<br /><br />Greg Hodges
  2. F

    Replacing gears in lower unit

    I have a 115 evinrude. I hit a rock & broke a hole in the gear case. I have another solid case that has some shifting problems. I'd like to switch gears from one to the other. <br /><br />Can this be done without the special tools in the manual? They show a pair of truarc pliers and a special...
  3. F

    Parts for 135 Evinrude rebuild

    Because of a shot piston, I'm considering a rebuild of my 1974 135 Evinrude. Since I'll have it apart would it be wise to replace all pistons or just the bad one? Compression is between 130-135 in the other 3 cylinders. Also should I replace the bearings etc?<br /><br />Also where is the best...
  4. F

    Cleaning Gasket sealer

    I installed a water pump on my evinrude 135. I had to take it off and I had the form-a-gasket on my hands. I just read a post that if there is any in the pump it's bad news. How would I clean it off?<br /><br />Greg Hodges
  5. F

    broken bolts

    Has anyone had any luck removing broken bolts? I recently purchased a motor with 3 bolts broken off. 1 is 1 of the 4 bolts attaching the gear casing to the exaust housing. The other 2 are in the powerhead. <br /><br />I tried an easy out on the bolt for the gear case but had no luck. Should I...
  6. F

    Water Tube Guides

    Where can I get water tube guides? Is there an Evinrude part #?<br /><br />Greg
  7. F

    Water Pump ???

    I installed a new water pump in the lower end of my newly acquired 73' 135 evinrude. How can I tell if it's working properly? <br /><br />Right now it appears that water comes out of two holes (1 on either side of the gearcase). It's a steady sream. I also notice a little water slowly coming out...
  8. F

    Tilt/Trim brackets needed 135hp evinrude

    I just purchased a 1973 135hp evinrude. After a few hours work, I was able to get it to run pretty strong. The only snag has been the tilt & trim. For some reason the owner had to cut the brackets that mount the tilt/trim motor. I got everything minus the cut brackets & pump. What can I do?<br...
  9. F

    I.D. Help

    I have a 135Hp Evinrude model#135483 B. Can anyone give me any info from that #?<br /><br />Thanks,<br /><br />Greg Hodges
Top