Search results

  1. 3

    Need help with '95 Ford 5.0 BID Ignition

    Getting the boat ready for summer, the engine will crank but not start, (I suspect most likely due to very weak spark) This past winter, I had a lot of water inside the boat due to a leaky tarp. So much so that I had to replace the starter. The whole engine was covered in condensation, with a...
  2. 3

    How do I get all the oil out?

    I have a 1994 OMC(Volvo) 5.0FL engine on my boat. When I bought it, it came with the brass "plunger" hand pump that screws onto the dipstick tube to get the oil out. However, when using this pump, a good amount of oil remains in the sump. What am I missing with this hand pump, and how do I get...
  3. 3

    OMC Ford 302 Manifold - using Barr Indmar from Osco??

    So, my much anticipated manifold/riser kit from GLM arrived. I noted the mating surfaces to be really bad - su much so that I contacted GLM to obtain replacements. Then, a tech suggested using a Barr/Indmar universal setup from Osco. Now it seems as if it could work - with the only issue being...
  4. 3

    OMC Nuts & Bolts - Home Depot OK or Volvo?

    I am in the process of replacing my manifolds, and would like to replace the nuts and lock washers holding the manifold to the studs. Now would galvanized nuts from Home Depot work, or do I need to get them from Volvo? Are there quality differences? 34S.
  5. 3

    OMC FWC Thermostat question

    Based on the parts diagram at Doug Russel, I ordered a new 160 thermostat, o-ring, and gasket. (they are of course also shown in the OMC manual) Then, when I started to dismantle all the hoses, brackets, I realised that my engine has a fresh water cooling (closed) system, and that the...
  6. 3

    Paint on new OMC Manifold Riser mating surfaces??

    I just received my new manifold and riser kit from GLM. I noted that all the mating surfaces - manifold to gasket, and manifold/riser - are all painted. Should these be sanded down to bare metal before installing, or are they good to go as long as they are flat/flush? Thanks for any advise. 34S.
  7. 3

    How to re-torque?

    Plan to replace my exhaust manifolds. The manual states to re-torque the manifold bolts after the engine has reached normal operating temperature. So, when re-torquing does one: 1. Loosen the bolts just ever so slightly before torquing them? or 2. Just torque them at the appropriate ft/lbs...
  8. 3

    What Gasket Sealant for Thermostat

    I will be replacing the Thermostat on my engine. The repair manual states to "coat both sides of the new gasket with gasket sealing compound". Now I walked into my local auto part store the other day, and was dumbfounded by the huge selection - silicone, rubber, RTV, gasket makers, etc, etc...
  9. 3

    AAaarrgghh! New user needs help . . .

    . . . with the voices in my head that convinced me to go buy a boat . . .:mad: New member to the forum, having just bought a 1995 Seaswirl 201 Cuddy, with OMC Stern drive (Ford 302/SX) So, I have lots of questions, but hopefully I will find the answers through Search or the Service Manual I...
Top