Search results

  1. I

    95 9.9 wires from under flywheel pushing idle forward

    This is a 95 J10RELEOE remote electric start. The wire harness from under the flywheel pushs back against the timer base and causes idle to increase. I replaced the control cables thinking it was stretch that was the problem. They were set by following the instructions in my OMC service manual...
  2. I

    Seloc manuals

    Just how good are they? They offer online subscription and Evinrude doesn't except for 97 amd later models.
  3. I

    J10RELEOE Need new motor cable end

    I'm in need of a replacement for motor end. Noticed that the outer cover has cracked and the insulation has also. I can grt a wateroroof industrial plug thru McMaster Carr but prefer to stay with oem. Also is there a good source for a drive shaft and shift linkage for short shaft because this...
  4. I

    proper way to start 86 9.9 electric start from remote control

    What is the correct wayq to start this motor? I'm new to the electric start with remote controls on it. Thanks
  5. I

    Carb kit for 18hp 58 Fastwin

    I just got a carb kit and it seems not to be the correct one. Its from Sierra part number 187043. It doesn't have the rubber packing for the needles. Is this the correct part number with parts missing?
  6. I

    89 9.9 Evinrude kicks out of gear

    This started happening after hit some junk in the water. It seems to happen when I go into high speed and it is not always popping out. When it does I just throttle down and put it in neutral and shove it back into gear and away we go. Do you think something could have happened to the clutch...
  7. I

    1989 9.9 RPM's

    What should the rpm's be for WOT on this (>( Evinrude. Seems like I readed somewhere it should be about 5000-5500 no load. Is this correct? Thanks in advance for any help on this.
  8. I

    Johnson ShipMaster Parts

    Does anyone have a source for the nylon gears in these units? I have one that the end broke off and there is no fixing it. I don't want to give up this trusty unit because of it! Thanks for any help. James
  9. I

    1954 Johnson 5.5 manuals

    I am looking for a service manual and parts manual for this motor.I need to do some things on it this year and it's easier to order parts with a manual rather that geuss. I don't know haw to PM so if you can email it to me at j_simmons6@sbcglobal.net. Thanks for any help you can give me.
  10. I

    89 9.9 Timing plate sticking/rough when turning throttle

    I am setting this motor up for remote control and noticed that when I push on the throttle lever arm at the engine it binds then it will go somewhat free then bind back up. It does not do it constantly. I tyrapped the ignition wires up so they would not rub to eliminate them. Could it be the...
  11. I

    89 9.9 Evinrude fuel pump problem

    Greetings, I just rebuilt my carb and fuel pump(No diagrams with it). Motor idles fine but when running up to WOT it dies unless I pump the primer. Could I have rotated a gasket wrong in the pump to cause this or would I have the same problem at idle. I have checked all fuel line connections as...
Top