Search results

  1. S

    1970 60hp Hydrostatic, igntion switch

    I was wondering if anyone, could tell me how to wire the ignition switch for this motor, came without the key and ignition..the motor i have now, i just wired a killswitch and a push button ignition, but looks like there is more than just a powe in/out and 2 grounds for kill..also can't find the...
  2. S

    1963 Johnson 40hp super seahorse..forward gear

    finally got my motor up and running..tested forward neutral reverse, at home new type- c oil...took it out on the river here, was running well, doin a good speed then it started jumping out of gear..slowed down turned around to go back to dock, still jumping out of gear....got it back, mostly in...
  3. S

    1965 40hp johnson carb problems

    ok..so icleaned my carb again. needle valve was plugged up...now when i prime the bulb fuel comes out of the throat...but fuel is also coming out of a small hole beside the low needle adjustment, is there suposed to be a plug of some sort in there...I cannot find it in the manual or any carb...
  4. S

    1963 Johnson super seahorse 40hp cooling system

    I pulled the bottom end off, submerged it in water and ran shaft with drill, the impeller is pumping lots of water, comes out at a good rate..my question is....the motor does not have a thermo:rolleyes:stat or relief vale in the housing. Could this be directing the water straight back back into...
  5. S

    1963 Johnson super seahorse 40hp, runs rough when hot

    The motor seems to be sucking water but not sure if it's enough....when you bring up the rpms more water comes out..Pretty sure this is how its supposed to be...as soon as it gets hot the motor begins to back fire and run rough..is this because the motor is not being cooled properly or because...
  6. S

    1961 Evinrude LarkIII 40hp

    I just got a boat for free and plan on restoring it, pulled the floor and seats.Tried to fire up the motor and would not start.It is electric start tried to get that running, but power and ground wires are very corroded, so we tried pull it..gass gettin to filter, checked and replaced...
Top