Search results

  1. B

    FICHT service code 25

    I have a 2002 Evinrude FICHT 200 hp. Keep geting service code 25/slow mode after 20 min run time. Replaced water pump, thermostats, water lines are clear through EMM. Any ideas? Thanks
  2. B

    02 FICHT 200 hp EMM Overheat?

    After several minutes of running, check engine light comes on and engine enters SLOW mode, believe that EMM might be overheating, appears it is getting water flow, possible vapor sparator issue? What is the best way to check water flow through EMM? tks
  3. B

    FICHT 200 hp stalling after 3/4 mins on plane

    2002 Evinrude FICHT 200 hp recently changed fuel assembly after test port failed, replaced with updated assembly w/o port, fuel looks clean/no water, idles fine but after coming up on plane for 3 to 4 mins roughs rough, loses power and has bad exhaust, check engine light comes on. After...
  4. B

    2002 200hp FICHT fuel assembly replace

    I suffered a failure of the fuel test port on the starboard fuel assembly line which requires replacement. Apparently this is not uncommon but fortunately I did not suffer fire damage as many others have. They have since removed the test port from the new replacement part. I have the part in...
  5. B

    02 Evinrude Ficht fuel test port problem

    The fuel test port blew out of my 2002 200 hp Evinrude Ficht. There is no way to replace without replacing the entire fuel manifiold assemblt. Can I temporarily bypass the port by cutting it out and splicing the line with a brass coupler and some clamps? I know the line is pressurized with...
  6. B

    Fuel pressure test port

    Just put the boat in for the season after completing spring maintenance. Fired up perfect and after 3-4 minutes run stop engine started stalling, strong smell of gas. Took engine cover off and found that fuel pressure test port had ejected itself into engine compartment and was spraying gas...
  7. B

    2002Evinrude Ficht 200 Starting problem

    I have a 2002 evinrude Ficht 200 hp and recently developed problem starting. I have a good battery and from what I can see good terminal connections from battery to motor. When I turn the ignition the starter turns but fails to engage the flywheel as if it is not getting enough "juice" from...
  8. B

    Evinrude FICHT alarm sounds in reverse

    I have been having a problem with my 2002 200 hp Evinrude Ficht. The check engine alarm sounds only when the engine is put in reverse at low rpm after having been operated in the forward position. This typically happens when backing into my slip. Short of checking the codes diagnostically...
  9. B

    Float Switch Blows Fuse

    I have a Rule float switch on my bilge pump which immediately blows the 10 amp fuse when thrown in the on position. The bilge works fine with the switch on the control panel. I upped the fuse to a 20 amp which still blows. I cannot find any wiring issues. The fuse is inline a few inches from...
  10. B

    Evinrude Ficht warning signal

    I have a 2002 Evinrude Ficht 200 h.p. Recently while starting the engine on the water after being operated all day, the audible warning horn remained on at start without any accompanying lights on the dash. I was able to disable the horn by turning the key to the left just enough to turn off my...
  11. B

    2002 Evinrude 200 question

    There is a tube that runs down to the lower unit which i am assuming is a vacuum or pickup for the speedometer. It was attached to a plastic nipple with a wire tie. The nipple cracked off. Is this screwed in or just a plug in and how do I replace it. Half of the nipple is still in the hole...
  12. B

    spark plug specs for Evunrude 200 Ficht (2002)

    I am looking for the sparkplug specs for a 2002 Evinrude 200 hp FICHT as well as indexing info.Thanks in advance.
Top