Search results

  1. R

    Alpha One-g1. Shift problem when Tilted

    What happened? Well, the unit that SEI sent as a rebuilt lower unit was not assembled correctly. Forward was just a bit past the capabilities of a shift cable. I sent it back and got a replacement the next week. I had it put together and installed in two hours. Running like a top.
  2. R

    Alpha One-g1. Shift problem when Tilted

    Well... I've pulled it all apart a few times last week. 1. The shift cable brass nut is definitely installed all the way. 2. The shift cable is working perfectly and is adjusted to the correct 6 inches measured between the barrel and the plastic piece that attaches to the shift / throttle...
  3. R

    Alpha One-g1. Shift problem when Tilted

    Yes, I believe I will pull the outdrive off again, and double check that set screw as well as the brass nut. Basically re-install the shift cable again without pulling it all the way out. It was quite difficult to reach down there and route it to the starboard side.
  4. R

    Alpha One-g1. Shift problem when Tilted

    Yes. I've taken it off the bracket. Pushed in all the way. Had the wife confirm it is locked in forward (counter clockwise) and hold in place. Measure 6inches from barrel to eyelet and install on bracket. Still.... It goes into both forward and reverse when the tilt is up (as if on...
  5. R

    Alpha One-g1. Shift problem when Tilted

    1984 Welcraft Nova 23 / Mercruiser 260 / Alpha one gen1. After replacing the entire out drive and the lower shift cable I have run into a strange occurrence. The thing will shift into forward (counter clockwise on the prop) and reverse (clockwise on the prop) when it is tilted up for...
  6. R

    shift rod - Johnson J150EXEDB

    Adjusting the new shift cable doesn't throw the arm enough to engage reverse. It has "popped" into reverse but the RPMs are rising and i'm sure it will destroy something. I suppose the shift rod is not at correct length. Maybe it's the clutch dog, but I hope not. What is the correct length...
  7. R

    Tilt & Trim bleeding down J150exedb

    What do I fix (test) first? The t&t motor runs fine, she has plenty of fluid, and no air in the system. I jack her up and she falls due to gravity. (takes about 30 seconds) I don't know if I should buy a seal and o-ring kit, or a new valve body, because I don't know how it works internally. It...
Top