Search results

  1. C

    3.0 mercruiser power problem

    I just took my boat out of storage. I put the muffs on it and hooked the battery up and lowered the motor down. When I turn the key all my gauges worked. But when I went to start it clicked like ot was going to start and then I lost all power. Any ideas what it could be? Thanks for any help.
  2. C

    mercruiser 3.0 tilt trim Question

    I recently had to replace one of my trim cylinders due to freezing and cracking over winter. So I got the new one on and got all the old milky fluid switched out with new. I was woundering how far your motor is supposed to raise up before you have to "trailer it up".
  3. C

    mercruiser 3.0 temp questions

    today I replaced to impeller on my 99 mercruiser 3.0 and put the muffs on it when i was complete and noticed that the temp went up to about 160/165 area when i usually run at about 150-160 area is this normal? I had plenty of water flow and this temp increase happened within about 10min.
  4. C

    how to check for bad impeller

    99 mercruiser 3.0 woundering how you can tell or check to see if the impeller is bad. Thanks
  5. C

    Mercruiser 3.0 starter problems

    Ok i have a few questions. First things first I have a 99 mercruiser 3.0 seial # if it helps is 0L317871. my problem is I first broke a starter bolt so I replaced both of them I figured this happened from just coming loose with time. When I fixed it I checked the starter gear and flywheel for...
  6. C

    merc 3.0 starer problems

    2 weeks ago i broke a bolt on the starter. i replaced both bolts and have went out 5 or 6 times since then with no problems. now today i took it out and started fine at the dock ran it all day till we decided to float for a while and then when i went to start it, it would start to start fine and...
  7. C

    mercruiser 3.0 water leak

    I am looking at buying a 99 maxum that has a water leak coming from what appears to be the manifold gasket. there is some rust spots running down the side of the block. are these gaskets hard to replace and what do i need to know before doing any of this.
Top