Search results

  1. F

    73 115 johnson dies when put into gear Electrical???

    carbs are very clean gas lines are fine gas is fresh motor dies the first second i put into gear if i rev it then real quick like put into gear and goose it it runs ok just dies at idle under load
  2. F

    cleaned the carb 5 times in as many days 115 still dies when put into gear

    help
  3. F

    low speed oriface on a v4 cross flow any body know about these things how they work d

    wanna check my low speed orifaces dont know any thing about them
  4. F

    help 1973 115 v4 dies when put into gear

    help i am at a loss runs fine at neuteral can rev it it idles put into gear dies instantly if i hold the warm up lever up drop it shift fast and goose it it ok runs alright drop it back into neuteral go to put into gear dies :confused: so far i have put in a in line filter cleand the bowls...
  5. F

    Im lost where should my motor sit

    hi I have a aprox 1973 17.5 foot mark twain bow rider and have been fighting with the motor the kept on running away and over heating got to thinking about it and saw the previous owners had reinforced the transom with pressure treated 2 x 12 on the out side doubled up and metal plates on the...
  6. F

    1973 115 johnson lack of power almost all of the time under load

    motor idels great
  7. F

    a 1973 115 reves up in nuteral and quits under way

    hey fellas after my last post about the 73 135 eating water pumps and decideing it was a bad exhuast gasket changed the water pump and gasket and ran good on ear muffs put it in the lake over heated bad this time figure the valves for the vernatherm melted again so i found another motor a 73 115...
  8. F

    1973 135 strange spark

    i just replaced the water pump and exhaust gasket went to put into the water and try it now the thing wont start i have spark in the 1 and 3 cylinders but on the 2 and 4 the spark is there sometimes and sometimes not also the starter seems slow the motor cranks slow I think the battery was ok...
  9. F

    1973 135 powershift two eating water pumps

    i just replaced almost every part of my cooling system all but the rubber deflectors was great for a little while then stoped pumping again opened up the lower unit and my brand new water pump and impeller are fried why? wasent ran outta water what makes a outboard eat water pumps
  10. F

    head gasket bubbles alittle 1973 135

    :confused::confused:i just replaced my whole cooling system and now the second gasket benith the spark plugs bubbles alitte is the head gaskets it seems to be metal runs ok
  11. F

    ok impeller is in but

    :)ok impeller is in but i have a small o ring does it go on the shaft by the splines or down by the pump houseing
  12. F

    My impeller dosent fit into the houseing

    :confused:got a water pump rebuild kit and the impeller does not fit into the houseing is this normal the old impellery looks like it diddent fit into the houseing either the blades are bent to allow it to fit wtf is that all about:confused
  13. F

    135 power stroke two not cooling

    just bought a boat with a 135 power stroke two ran great for a couple of minutes but looked like it wasent shooting out water right ithink the two holes at the top then stoped all togther how do i check the cooling system ? :(
Top