Search results

  1. S

    lower unit to upper unit installation

    For mercruiser stern drives about 1988..I just put the lower back onto the upper unit (upper already attached to the boat) had a little trouble lining up the bar that comes from the upper to the lower to adjust drive/neutral/reverse---what is the easiest way to check that they are lined up...
  2. S

    trim tab

    it seems that the trim tab adjuster screw on the top side came loose or fell into the hole and I can't get to it --any ideas on removal of this piece?--need to get it off to get to other bolt for separating the upper and lower units
  3. S

    lower unit

    How do you separate the upper and lower units? there are 5 main bolts that seem to hold them together. After loosening all 5 I could not get the 2 to separate. Am i missing a bolt or something? I now have disconnected the upper and lower as 1 piece from the rest of the boat as I had to check...
  4. S

    starter question

    had a click from back of boat when starting but starter did not engage...when I put a screw driver to the start cyl points A and B, it would start. I ran electrical wire from these 2 points up the side of the boat 2 a $2.00 door bell I bought at lowes. Now I turn the ignition key to on, and...
  5. S

    oil filter

    oil filter stuck and can't get off. have used oil filter removal tool and it just crushed the oil filter and won't loosen--any ideas on how to remove?
  6. S

    engine/transmission problem

    :mad: was boating at full rpm and engine seemed to pop into neutral, stopped engine, restarted and could not get back into forward or reverse--got boat out of water, traced throttle lines to back of engine and checked for broken or impeeded parts and found none. started boat in driveway, and...
Top