Search results

  1. F

    2000 Johnson 90hp Carbs

    Thanks so much, that gives me a starting place.
  2. F

    2000 Johnson 90hp Carbs

    It is also pre mix
  3. F

    2000 Johnson 90hp Carbs

    I have 120 comp on all 4, the engine will run 40mph @ 5400 rpm's, It just will not idle.
  4. F

    2000 Johnson 90hp Carbs

    120 on all 4, I have already checked everything on the engine. I need to know the proper settings for the carbs. Thanks
  5. F

    2000 Johnson 90hp Carbs

    Also, When I turn the idle air needles in or out it changes the way it idles so I figured it had to be the carbs. I'm trying to get the settings for the air and set it back to factory to see if it will idle.
  6. F

    2000 Johnson 90hp Carbs

    I had the powerpack, coils, plugs and sensor replaced and the idling has gotten worse since. Do you think it is the bowls or the carbs need kits? Thanks for your input.
  7. F

    2000 Johnson 90hp Carbs

    I have a 2000 Johnson 90hp that idles rough with the air screws 10 turns out. If I run them in to 5 or 6 turns it will not idle. How many turns out are these carbs suppose to be set at? What type of carb issues causes this? Thanks for your help!!
  8. F

    Heavy Smoke at Start Up ????

    1991 Johnson 200hp. When I started it up today I had a tremendous amount of smoke and a unsmooth idle. When I increased the rpms it smoked even more. It was stuttering last weekend until I got above 1000rpms, then smoothed out. I checked the firing and it is steady on all cylinders. This is...
  9. F

    Wiring inside trailer ?????

    I have a 25' boat trailer with the light ran inside the trailer beams. The old wiring needs to be replaced with new. When I try to pull it out with new wire attached, it keeps getting hung up. Is there a way to run new wiring through the beams by pushing some type of heavy wire through first...
  10. F

    johnson 200hp lower cowl removal help needed

    1991 Johnson 200hp J200TXEIB I recently removed my lower unit to replace impellar and forgot to adjust shift rod height, so the reverse is not engaging properly. When I put the lower unit back on I tightened the shift rod bolt to tight and twisted the head off. I don't think it will be hard to...
  11. F

    200hp Thermostat question

    J200TXEIB 1991 Johnson 200hp. I removed the thermostats when I bought this boat about a year ago because I thought I had a overheating problem but it ended up being carbs, tuneup, and electrical issues. I got all that repaired. I have been running it without thermostats since last fall and...
  12. F

    Wiring Diagram Attached. Need Advice On Wire Location

    1991 Johnson 200hp, J200TXEIB. I recently replaced my Stator, Regulator/Rectifier, and Powerpack due to the rectifier shorting out and catching fire. After doing more research on my engine today, I cannot get to shut down without choking it. The engine is running good and firing on all...
  13. F

    Engine wont shut down!!!!!

    Re: Engine wont shut down!!!!! I appreciate that. After doing more research on my engine today, I cannot get to shut down without choking it. The engine is running good and firing on all cylinders. It starts as soon as I turn the ignition switch. The only question I have is the wiring coning...
  14. F

    Engine wont shut down!!!!!

    My engine will not shut off when you turn the ignition off, and the Tach stopped working. it slows down an finally boggs out, but does not shut down immediately. Does this sound like the ground?? Advice appreciated.:confused:
  15. F

    Ignition switch works sometimes ????

    I have a 1991 Johnson 200hp that starting misfiring. Now the ignition switch will not engage starter everytime. Sometimes it will spin the motor but appears to be firing weak. Then the next time you turn the key you get nothing. I checked the battery connections and they are ok. There is about 6...
  16. F

    Johnson 200hp electrical advice needed....

    1991 Johnson 200 J200EXTIB. I recently replaced my Regulator/Rectifier, Powerpack, Stator and Timer Base due to a fire caused by my Regulator/Rectifier shorting out. I also replaced the ignition dur to it not activating the electric choke when pushing the key in. Everything was working good...
  17. F

    Water getting in foot??

    I have a 1991 Johnson 200hp that is getting about 1/2 cup of water in the foot each trip. Is this a seal behind the prop? And, is this hard to replace or should it be done by a Tech?? Will this damage my foot if I keep the oil changed?? Thanks __________________
  18. F

    How to repair an electric choke on 1991 johnson 200hp???

    I have a 1991 johnson 200hp model J200TXEIB that the electric choke is not working. I replaced the ignition switch but did not fix the problem. The engine will not start without priming it first, but runs and starts great after you run it 20 or 30 seconds. I need to know where to start to repair...
  19. F

    Johnson 200hp Primer Solenoid Advice Needed

    1991 johnson 200hp J200TXEIB , I just replaced the regulator/rectifier, stator,timer base, and powerpack due to the regulator shorting and catching fire. The engine runs great after you get it started. When I push the key in to choke in it stops the motor from spinning. I do not know if it was...
  20. F

    1991 Johnson 200hp Powerpack and Regulator Wiring Help Needed

    I recently changed out my Stator, Regulator/Rectifier, and my Powerpack due to the Regulator catching fire. I'm not sure how the wires go back onto the Terminal Block at the back of the regulator. I have a manual but the schematic is confusing. Does anyone have a clear wiring diagram that would...
Top