Search results

  1. J

    Wiring between stator and rectifier regulator on 1998 225 ocean pro

    friday noticed my Tach was showing 0 while at idle and up to around 3000 rpms. At the same time my voltage showed 13.5-14v. Then suddenly at around 3000 rpms the tach would suddenly start working and the voltage would shoot up to 16.5 and climb to 17.5 with increased rpms. The exact same...
  2. J

    1998 225 Ocean Pro idling very high....2000+

    Finally got enough time to replace the stator and rectifier the other day and everything seemed fine(also a new prop which got my rpms up to 5700.) Went fishing yesterday and the neutral idle was high at around 1500rpms while in the water. in gear at idle it was its normal 900rpms(which is a...
  3. J

    another stator burnt

    pulled the flywheel to check out the stator while replacing the rectifier on my 1998 225 ocean pro and found it burnt again so as I figured we would have to do gotta replace another stator. Something is obviously burning the stator and recitifier up as this is the 2nd time we have had both...
  4. J

    not quit enough RPMs

    I have a 2004 RG 2100 Sea Chaser(21' 4" with a 9ft beam and pretty heavy for the size) with a 1998 225 Evinrude Ocean Pro. While running WOT with the motor DOWN I am getting 4800 RPMs and 40 mph and WOT with the motor trimmed UP I am increasing to 5100 maybe 5200 rpms and about 45 mph(both...
  5. J

    voltage problem

    while running my 1998 225 ocean pro is only making 11.7 volts. should be 14+ and it has been getting weaker it seems as last week it was making 12.2. I have checked all the connections, grounds, batteries, etc and all seem fine. I replaced the rectifier/regulator the year before last but it...
  6. J

    1998 225 Ocean Pro tilt and trim leaking up in reverse

    My tilt and trim is leaking up when in reverse....i can even just grap the motor and very slowing ease it upwards. It holds fine will running trimmed up and it raises and lowers fine just leaks up a little in reverse. I have checked the manual release screw and it is tight but I have not taken...
Top