Search results

  1. A

    OMC Cobra, will not go out of reverse when running

    I had some problems with shifting. Mechanic replaced cable from top of engine down to gears. Now it will not go out of gear, until I shut engine off. Anyone got any ideas on what is wrong? I want to make sure I can be specific on what should be looked at. They can not get to look at...
  2. A

    Control Arm neutral lock worn, Does not lock sufficient.

    The plastic stop for control arm is worn and no longer prevents movement of control arm from going into gear. Are there any replacement locking arms.
  3. A

    Thrust Plate sheared off, 86 4.3L OMC Cobra

    I just noticed the thrust plate is sheared off. Is there an easy way to change it? I fear the stubs from the old one is in the unit. Is this a problem?
  4. A

    Timing setting 1 btdc or 6 btdc . OMC 4.3L

    The manual has two different settings for timing. 1degree btdc and 6 degrees btdc. I see no explaination as to which should be used. Last tune up I had done, the mechanic changed it from 6degrees to 1 degree. It seems to still run ok. But would like to find out why the difference. I would think...
  5. A

    OMC ESA module

    I have a 1986 4.3L V6 OMC Cobra. I believe my Electron Shift Assist module is bad. Since when I activivate the switch, the engine dies. According to what I have read it should only change the timing to lower the idle during the gear engaging. Is there any way to check this other than what I...
  6. A

    Restoring throatle linkage on 86 OMC 4.3L 2b

    Hi,<br /><br /> I am trying to restore the linkage back to original configuration. The prior owner changed it from pull to push. The problem is that I seem to be missing one link. The manuals I have do not show the complete assemply so I can not tell exactly what is missing. Is there some...
  7. A

    refinishing Teak trim and platform

    Hi, <br /><br />I have a 86 EbbTide IO that has a teac deck on the back and various teac plates and trim. I removed these to refinish them, but other than sanding and varnishing I am not sure what is best. The deck is at water level and pretty faded. I don't want to spend all summer sanding and...
  8. A

    Engine Oils, what is best for an 86 4.3L 2b OMC ?

    I am looking for information on what are the best brands of oils to use in an older OMC 4.3L engine. Book calls out for 30W SF detergent. With some GM spec. that I can not find on any 30W oil.<br /><br />Would Synthetic be a good idea or just a good 30W SH/SI HD?<br /><br /> :rolleyes:
  9. A

    86 , OMC 4.3L Oil and filter options

    The book says API SF 30W oil. I can find the OMC version for $5.50/qt. I did not find any other oil that was SF, or the other specs. most oil containers only had that the oil was great and met specifications, but did not say what specification. Is there any alternatives? like the synth oils...
  10. A

    Purchase 4.3L OMC 2b, 18ft EbbTide Riveria

    I am considering purchasing this boat. It has been primarily used for skiing. <br />This is my first boat purchase and I would appreciate any suggestions on what to check and consider prior to finalizing the purchase. <br /><br />I plan to use this for family cruising and fishing.
Top