Search results

  1. P

    Serious hull edge damage from concrete grinding.

    Looking to buy a newer Four Winns with hull damage. It has serious hull edge wear from being washed up on concrete ramp or something it looks. Any advise or directions toward hull edge damage like this? Here is a link to a pic of the worst damage...
  2. P

    rythmic clunk when I engage forward or reverse with ear muffs on (solved, w/ answer)

    So I pulled my outdrive to replace the gimbal bearing and after putting it all together I hooked ear muffs and fired it up in driveway. No more gimbal bearing noise at idle. I then decided since I had the shift cable out to replace bellows I would try putting it in gear (which I have never done...
  3. P

    Have searched and read on shift cable bellows, need some clarity, have a pic for ref.

    OK, I have searched and read for hours. Most say to pull the core cable first, then magically unscrew from the outdrive side and pull out the outer cable shield. This is where it gets dicey for me. I have it all apart up at the engine side. I did start to pull the core and it stuck at around 15...
  4. P

    1st time gimbal bearing try, broke puller, am I using wrong puller?

    So I went to Autozone and bought / rented the puller, slide tool, bearing driver. (guess I own the inside puller now) Anyhow, after happening about 25 times it broke. See pic. Should I try the axle bearing puller type maybe...
  5. P

    Can I change gimbal bearign with just outdrive removed or need to remove bell housing

    Is there a reason to pull bell housing to replace gimbal bearing or can it all be done with it in place and just the outdrive pulled?
  6. P

    Any chance of getting specific wiring diagrams for my boat?

    I have a 1995 Starcraft 22ft. It has an AUX. switch on dash and behind it has a wire coming off the switched output going to the harness. i have no idea what it runs. Is there a chance of finding legacy boat wiring diagrams?
  7. P

    Have nuts off, cant get outdrive to pop loose? slid back 1/2 inch, stuck. Any tips?

    So I picked up a 1995 a few weeks ago with a 5/7L, Alpha 1. Have a noise, think it is gimble bearing. Reading all the posts how a guy should pull the outdrive yearly so I started to tackle it this afternoon. Got 5 nuts off, 6th near off. It is broke loose but only will move back about ? inch. I...
  8. P

    yet another power steering question. (I searched, read, and started at cable, not it)

    OK, so I searched and read 8-10 posts with replies that recommend lubing the cable where it comes out of guide. Following these threads I removed the pin at end of cable and testing steering. It was then VERY easy & free. I then got out of boat and tried to swing the outdrive by hand and it was...
  9. P

    Have 24 ft. Midship Hurricane model questions Anyone have feedback on this model?

    Saw one on Craiglist. Never considered anything other than a deck boat for next boat. Kind of looked interesting. Was wondering if there is a midship owner out there that could comment on having it, etc. I nevr wanted a cabin boat because it negated the front open bown fro my teenage kids &...
  10. P

    Trim sender intermitant, can I clean/ open sender unit?

    In the middle of the ?stroke? of tilting the outdrive up the gauge shows the outdrive ?full up? for a while, then correct again. I assume in the sweep of the rheostat inside the sender there is some corrosion or something. I have read many posts after searching about replacing the sender being a...
Top