Search results

  1. W

    Johnson powershift 2 115 wont start.

    Re: Johnson powershift 2 115 wont start. Test the solenoid...
  2. W

    Johnson electramatic control

    Re: Johnson electramatic contrlo Re: Johnson electramatic contrlo Here's a wiring diagram:
  3. W

    Unknown Evinrude 15034 09563 Tiller handle question.

    Re: Unknown Evinrude 15034 09563 Tiller handle question. I was able to pull it up with the link in post #7. Not sure why you got the expired notice. Anyway, here's the diagram that you're looking for:
  4. W

    1971 25R71 Ignition rewire

    Re: 1971 25R71 Ignition rewire Here's a diagram for the '71 25hp:
  5. W

    neutral safety switch operation

    Re: neutral safety switch operation I don't believe there was an '80 90hp, but at any rate, that remote is probably very similar to my '79. Your problem could also be a key switch that is starting to fail, and not making contact between the B and S terminals on the switch. A continuity check at...
  6. W

    1970 Johnson ignition wiring problem

    Re: 1970 Johnson ignition wiring problem Here's a diagram for a '70 40hp. If you don't have an ammeter, run the red wire to the B terminal on the switch. Terminal ID's difficult to read in diagram. Starting at the bottom with BAT (B) then clockwise: M,S,A,M.
  7. W

    control box questions

    Re: control box questions You're missing 2 wires on that plug that has the purple wire coming out. That's a female plug, and you can remove it from the remote. If you want your tach and other accessories to work, you'll have to add the grey and black wires to that plug. purple = switched 12v...
  8. W

    control box questions

    Re: control box questions Hey ohfishcat, I was drawing some notes on your photos, and I come back and see that bob had already given you the scoop. I'll put them up anyway. Hope it helps.
  9. W

    1971 Evinrude 50hp Lark Electric Shift Gearbox Problem.

    Re: 1971 Evinrude 50hp Lark Electric Shift Gearbox Problem. As others have said, sounds like your green wire is shorting out somewhere. When you swapped the green and blue wires, your problem went from no neutral, to no reverse. Have to find the short in the green wire. Try the amp draw test...
  10. W

    Need help identifying proper jets

    Re: Need help identifying proper jets I'm working on a '79 Johnson 85hp that had mismatched carbs and jets. My service manual spec's the following jets for the 115hp: High speed: 54c Low speed: starboard - .027; port - .028 pic showing size markings
  11. W

    1979 Johnson 85hp - carbs

    Model 85TL79 - uncertain history Background: Picked up a 1979 15' Kingfisher bass boat, motor and trailer for $250. At that price, I didn't expect much out of the motor, so I was surprised to find that the motor had good compression numbers (125,133,125,125) and good spark. I had planned to put...
  12. W

    1994 Evinrude trim and starting problems

    Re: 1994 Evinrude trim and starting problems You can rule out a bad starter motor by using jumper cables to connect 12v directly to starter (key off). If starter motor is good, you can test the solenoid as described in the diagram below. You can rule out a bad trim motor by connecting 12v...
  13. W

    1978 85 hp Johnson V4 Starter Stuck engaged??

    Re: 1978 85 hp Johnson V4 Starter Stuck engaged?? Glad to hear you got the starter loose. There is a fuse between the solenoid and your harness plug (large red plug). If you can't find it, it may be wrapped inside the harness. Rather than spend too much time looking for it, I would just pull...
  14. W

    evinrude 90hp 1985

    Re: evinrude 90hp 1985 Turn your manual release screw out about 1.5 turns. Manually lift motor and engage trail lock so that you can access the reservoir fill screw. Remove the screw, and add fluid (atf ok) until it reaches the level of the screw opening. Replace fill screw. Flip back trail...
  15. W

    1978 85 hp Johnson V4 Starter Stuck engaged??

    Re: 1978 85 hp Johnson V4 Starter Stuck engaged?? Hello Ski-N-Fish. Let's start by attempting to rule out the solenoid as the problem. Do test in pic with key off...
  16. W

    Newbie here with a 3 part question

    Re: Newbie here with a 3 part question Hello zolkat. I'm including a few pics from my '79 - 85hp to try to help you with your questions. I believe that your 90hp would be 1981 or above. 1. Look for welsh plug on top of powerhead. Mine is on top of cylinder #2. 2. You will have to disconnect...
  17. W

    98 Johnson 115 spl Power Tilt Not Working

    Re: 98 Johnson 115 spl Power Tilt Not Working Clicking relay usually low battery, bad relay, or loose connections (ground or 12v). Sounds like you've covered the first two. Try doing what's explained in the pic below to rule out a bad trim motor.
  18. W

    1986 120 lower gear case re seal

    Re: 1986 120 lower gear case re seal Ran across some labor data and remembered your post.
  19. W

    1975 Johnson 85hp intake screens

    Re: 1975 Johnson 85hp intake screens Here you go... Shift rod measurements Video on making measurement tool http://www.youtube.com/watch?v=aBNZ_gMh5RQ
  20. W

    1975 Johnson 85hp intake screens

    Re: 1975 Johnson 85hp intake screens No problem. I took mine apart before ordering any parts. Was hoping that I would only need the impeller, but due to some wear on the impeller plate, I think that I'm going to go ahead order the WP kit... oh well. more pics
Top