Search results

  1. M

    Gel Coating problems

    Hey yall I have a problem. I put a new coat of gel coat on my boat and it doesn't seem to be setting up like it did the first time I did it. I think I know what the problem is but not for sure. The first time I did it it was a lot warmer outside (at least 80 degrees) this time it only got to...
  2. M

    unburnt fuel out of exhaust

    I need help with my 1984 50HP Mariner. When I am running my boat I start out at full power but after only a few minutes it sounds like I drop a cylinder. The motor doesn't miss or anything its just like I loose power. but I can shut it down for a bit to fish and when I start it back up it does...
  3. M

    50 hp mariner tilt problems

    I have a 1984 50 hp mariner. When I went to use the tilt and trim today my motor will lift but will not lower. I can hear the hydraulic unit come on when lifting but nothing happens when try to lower. I checked the wire going into unit and I am getting voltage to unit but nothing happens. Any...
  4. M

    battery charge issue

    I recently replaced my stator on my 1984 50 hp Mariner . The two yellow wires were not attached to anything and i was told they are for keeping my battery charged. I do not know where they are suppose to go . Can i wire them straight to my battery? If not can someone please tell me where to...
  5. M

    1984 mariner 50 hp idl problems

    Hey yall I got a problem, just cleaned my carbs on my 1984 50 hp Mariner. all jets are clean needle in good shape but when I go to start it on full choke it starts good but when i take it off choke motor revs high for few seconds then dies . I'm about to pull my hair out . please help
  6. M

    Need help with 50 hp mariner

    Hey yall I got a problem, just cleaned my carbs on my 1984 50 hp Mariner. all jets are clean needle in good shape but when I go to start it on full choke it starts good but when i take it off choke motor revs high for few seconds then dies . I'm about to pull my hair out . please help
Top