Search results

  1. C

    1995 Black Max VRO pump

    One of my engines VRO pump drive bushing went bad and caused the engine to go, still under warrenty luckily enough-rebuilt powerhead- Can I remove the VRO pump and reserve tanks off each engine and just premix oil and fuel in the 185 gal fuel tank. I know that I would have to disconnect the...
  2. C

    merc. inboard engine problems

    I have twin merc. 470/170 hp engines, one runs great,the other runs perfect at idle, in or out of gear,dies immediately if I give it any fuel at all.I have checked the points,cleaned and reset them to .022 by the book,replaced the rotor,cleaned the cap,ect and no difference is made.Checked the...
  3. C

    mercruiser 470/170hp water pump problems

    My engine has an internal water pump-seals have worn a slight groove on the shaft causing the new seals to leak.Does anyone have an idea of the diameter of the camshaft so I can get a set of speedi-sleeves to fix this.The engine is 300 miles away or I would measure it .Send info to...
  4. C

    Puzzled?

    I'm looking at buying a 24ft boat that is a 1977 Perfomer Cuddy Cabin Open Fisherman.Anyone know who the manufacture might be?
  5. C

    1968 85hp points gap

    My motor has 2 sets of points.Near the back of the engine(prop end)is stamped set to .010 gap.Is this for both sets of points or just the one near this info.If they are different what is the setting on the other one?
  6. C

    69 starflite evinrude v4 2 stroke

    I just replaced the stator due to a cracked wire end-engine started fine then wouldnt start and backfires when cranking- suspect the points-anyone have any ideas and what is the point setting as it has two sets.
Top