Search results

  1. 2

    Remove the engine with or without intermediate shaft housing?

    I need to pull the engine out to replace flywheel. Is it possible to remove the engine leaving the housing in place? The shaft is already removed. AQ271, DP-A single bearing intermediate shaft. Thanks
  2. 2

    Hep with U joint cross reference

    After reading the sticky and searching for U joints I have not come up with the U joint I need so I think. Marine shop says the whole unit needs to be replaced, I am having a hard time with that. Can someone please point me in the right direction with the right U joints that can replace mine...
  3. 2

    Rattle from drive when revved in neutral or hard take off in gear.

    After PDS bearing replacement I developed a rattle that sounds like its from the drive or Flywheel housing. At first it was only in neutral when I would give the motor a quick Rev, but now its giving a quick rattle when taking off from a stop. Also developed a vibration when turning left or...
  4. 2

    Shake down run!

    After replacing PDS bearings, new bellow, changed drive oil, and new impeller it was time for a splash. This boat has not touched water since 05. Running fat pig rich on idle. Vacumn was 12-14. Holley 80309 dual feed. Carb was rebuilt by me last year. New plugs soaked with fuel. Pulled...
  5. 2

    Sealed or Opend PDS Bearing

    My Flywheel Cover does not have a zerk fitting or access hole to apply grease to in the future. Wouldn't I want a sealed bearing Installed on PDS? There is a open bearing installed on shaft now and it is dry to the bone. Thanks, Nolan
  6. 2

    Please help Identify equipment!

    I have called several marine shops to find intermediate shaft bearings, seals, ujoints, and bellow. The model # I give them that are on the tags they say are no good. Shop wants $130 to identify the equipment. If you could please help that would be greatly appreciated. Also does engine need...
Top