Hello, I am rebuiding a 1990 Force 120hp,#1208x90B<br />And have had everything micrometerd and the shop says all is within tollerances, except the pistons wich I have bought new any way. But they took the main bearings off the crank and did not mark them to replace them back in the origanal...
Hello everybody, I have a 1990 120hp force # 1208x90b. I have found a NOS (new old stock)stator that I want to purchase if it is the right one. The # on my current stator is FCC3007F it has a total of 6 wires on it 2 yellow and 4 brown (prestolite). The new stators # is FCC3007K and has 2...
Hello, In my last post I was'nt clear, sorry about that. What I was wondering, will a stator and trigger assy. from a 90 or a 150hp force fit on a 120hp of approx the same year. I looked for part #s in the mega mall but none for 90, 120,150HP. Does anybody have a link or first habd knowlege...
Hell everybody: Just wondering, Does the 85, 90, 120, 125 and 150HP force motors use the same ignition system, ie. stator, trigger, flywheel,coils and cdi boxes? from around the same era, 1986-1992? or so. Thanks Ray
I am going to rebuild my 1990 120hp force model# 1208x90b, Just need to know what should be done during break in? Also is there any little secrets that I should know before I rebuild? Thanks
hello again, my last post I explained my motor blew,. It was a 1990 120hp force # 1208x90b motor. The bottom piston broke on the exhaust side and trashed the rings. the motor had a pop or sneeze at low rpm when cold and would cause it to die, but as it warmed it was better, before it blew it...
Hello I have a 1990 force 120hp, model 1208x90b out board, I just lost the #4 cylinder during a 5 minute run @ about 5400 rpm. I think I just burnt the piston from over rev. But just wondering if I could have lost the cyl. because of water in the hole? I dont see any cracks in the block nor did...
