Search results

  1. DPManley

    A new old Sunfish...Or Sailfish

    Hello Iboats. I spend a lot of time over in the repair forum while working on my fiberglass Larson. Now we have a new project. I got such great advice on fiberglass, I took a look in this forum and see the same enthusiasm. Let me know if I need to move over to the repair forum. This week, my...
  2. DPManley

    Epoxy or Polyester - Which for a renovation

    Re: Epoxy or Polyester - Which for a renovation I was able to re-size some pictures. This was before I removed the floor. When I took up the floor, I found this. As Mentioned, I started replacing the frame, then read the threads on proper replacement. DM
  3. DPManley

    Epoxy or Polyester - Which for a renovation

    Re: Epoxy or Polyester - Which for a renovation OK Thanks guys. I may change the title but moving on here for now. So I removed the floor and found a support frame that sits on top of foam filled stringers. I had planned to simply replace the frame and floor. I posted this picture: That's...
  4. DPManley

    17' Larson Keel repair-am I on track?

    This is my 1967 Larson (model unknown) Part of my winter repair is to properly repair the hull. It has a lot of wear and several PO repairs. I cannot flip the boat so I am working upside down and on the trailer. I will lift the boat slightly so the roller is not blocking my work ? should be...
  5. DPManley

    Epoxy or Polyester - Which for a renovation

    Well, I read so many great threads in the forum that I thought I was going to just post after I finished. Right off the bat, I have a question. First the situation: 1967 Larson (I don't know Model) about 17' Square glass, outboard. 1978 Evinrude 85 HP - Engine runs strong. I replace impeller...
  6. DPManley

    1978 85HP Evinrude stuck gear shaft

    Re: 1978 85HP Evinrude stuck gear shaft I found this diagram (I'm not sure if it will display - I am new) I removed screw #61. #58 is the angle pin I described. From this, it looks like I need to get to #45 and remove screw #66 as you described. So far I cannot see any of this from the...
  7. DPManley

    1978 85HP Evinrude stuck gear shaft

    Hi All - my first post. I have read a BUNCH of posts and I am still stuck. I have a 1978 85HP Evinrude. The impeller has not been changed in years. Overall, running well. So I followed the manual to drop the lower unit. It says to shift into reverse and remove the shift lever bolt - done. All...
Top